EasyApplianceParts is now PartSelect! We've merged our sites to provide a better shopping experience for you.   Full Details
✖

Find Parts

Parts Departments

Top Model Types

Top Brands

Repair Help

Expert Repair Videos

Keep typing for more specific results...

KSBP23INSS00 KitchenAid Refrigerator - Overview

Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Whirlpool EveryDrop3 Refrigerator Water Filter – Part Number: EDR3RXD1
$84.45
In Stock
Whirlpool EveryDrop3 Refrigerator Water Filter
★★★★★
★★★★★
(114)
Part #EDR3RXD1
This EveryDrop Filter3 is certified to reduce the most contaminants with Triple Filtration Technology. Now, you and your family can enjoy the enriching benefits of cleaner, freshly filtered ice & water. Not just in beverages, but for preparing meals, too. This advanced generation of ice and water refrigerator filters from EveryDrop Filters are certified to reduce more contaminants with Triple Filtration Technology. Filter 5 reduces 16 contaminants, so you can feel reassured that you and your family are getting the most out of your water. Remember to replace your refrigerator filter every 6 months to maximize contaminant reduction.
Refrigerator Lower Door Closing Cam – Part Number: WP2182179
$9.62
In Stock
Refrigerator Lower Door Closing Cam
★★★★★
★★★★★
(94)
Part #WP2182179
The lower door closing cam is used in refrigerator doors, it can be located on the fresh food side or the freezer side. It helps hold the door open. This cam is made out of plastic, so it might crack or wear down over time. If your door will not open and close properly you may need to replace the door closing cam. To successfully install this part, you will need a 5/16 nut driver and a small flat blade screwdriver. Before you begin, unplug your appliance and disconnect the water supply. Lubricating this part may help with installation. This replacement part is sold individually. This part will fit both the left and right side of your refrigerator door. To make the repair, remove the top hinge cover, then the top hinge support. Lift the door from the bottom support and remove the old door cams. Replace the cams, using a little lubricant if necessary, and place the door back on the lower hinge support. Replace the top hinge support and your repair is complete!
Ice Maker Assembly -  8 Cube – Part Number: 2198597
$120.55
In Stock
Ice Maker Assembly - 8 Cube
★★★★★
★★★★★
(116)
Part #2198597
This Ice Maker (Icemaker Assembly, Complete Icemaker Assembly, Ice Maker Assembly, Refrigerator Ice Maker) can be used with 25-27 cubic feet refrigerators that have a vertical auger dispenser located on the freezer door. It’s used to make ice. When this part fails, no ice cubes will be made. It could prevent the icemaker from filling with water or just prevent the harvesting of the ice cubes. This is a sign the part should be replaced. The parts electrical contacts and motor can fail due to normal wear and tear. The icemaker attaches to the ceiling of the freezer compartment. This assembly measures 11 inches by 5 inches, is constructed of plastic and metal, and comes in black/white.
Icemaker Control Assembly – Part Number: W10190935
$70.95
In Stock
Icemaker Control Assembly
★★★★★
★★★★★
(31)
Part #W10190935
Automatic ice harvesting relies on this refrigerator ice maker control module and motor assembly to coordinate the operating cycle. Located behind the ice maker cover, it drives the ejector mechanism and controls the sequence for loosening, releasing, and refilling the ice mold. A failed module may leave cubes stuck in the mold, stop the ice maker from cycling, or cause unusual clicking during operation. Water supply problems and incorrect freezer temperatures can cause similar symptoms, so a lack of ice alone does not confirm module failure. This is an OEM part sourced directly from the manufacturer.
Refrigerator Ice Guide – Part Number: WP2180224
$17.15
In Stock
Refrigerator Ice Guide
★★★★★
★★★★★
(63)
Part #WP2180224
This is a refrigerator ice guide that is made entirely of clear plastic. This ice guide is located in the freezer door. Turn your refrigerator ice dispenser off before replacing the part. This is a simple repair, and the only tool you will need is a small flat blade screwdriver to push on the pivot tab on the bottom of the ice guide. Do not worry about breaking the side or pivot tabs on your existing ice guide because it will be discarded anyway. This is a genuine manufacturer replacement part.
Water Filter Cap - Black – Part Number: WP2260518B
$35.80
In Stock
Water Filter Cap - Black
★★★★★
★★★★★
(74)
Part #WP2260518B
This black cap covers the water filter.
Refrigerator Door Switch – Part Number: W11384469
$30.53
In Stock
Refrigerator Door Switch
★★★★★
★★★★★
(95)
Part #W11384469
If your refrigerator’s interior light is not working, the door switch may be the cause. It turns the light off when the door closes. This is an OEM part. Confirm compatibility using your refrigerator’s model number.
Refrigerator Bimetal Defrost Thermostat – Part Number: WPW10225581
$34.74
In Stock
Refrigerator Bimetal Defrost Thermostat
★★★★★
★★★★★
(30)
Part #WPW10225581
If you have ice building up in your freezer, or if your freezer is getting too warm during the defrost cycle you may need to replace the bi-metal defrost thermostat. The function of the defrost bi-metal thermostat is to clip onto the evaporator and protect your evaporator from overheating during the defrost cycle. If your refrigerator does not defrost properly you can test both the thermostat and the heater to figure out which part is at fault. For this repair, you will need a Phillips screwdriver, a 1/4 inch nut driver, a flat blade screwdriver, a pair of wire strippers, a roll of electrical tape, and a few butt splice connectors.
Light Bulb - 120V 25W – Part Number: WPA3073101
$19.69
In Stock
Light Bulb - 120V 25W
★★★★★
★★★★★
(10)
Part #WPA3073101
This appliance light bulb illuminates the interior compartment so stored items are easier to see and reach. Its clear glass design allows light to spread through the surrounding area, while the incandescent filament produces light when powered. A burned-out filament or damaged bulb may leave the compartment dark. Replacing a failed bulb helps restore interior lighting. Disconnect appliance power and allow the old bulb to cool before removal, then gently screw the replacement into the socket without overtightening and reinstall the protective cover. This is an OEM part sourced directly from the manufacturer.
Refrigerator Dispenser Overflow Grille – Part Number: WP2206670B
$37.91
In Stock
Refrigerator Dispenser Overflow Grille
★★★★★
★★★★★
(25)
Part #WP2206670B
This grille is located on the bottom of the ice/water dispenser to catch the overflow. (Black)
Ice Door Kit – Part Number: W10823377
No Longer Available
Ice Door Kit
★★★★★
★★★★★
(44)
Part #W10823377
In this kit you will find the support, the ice door, spring, and delay. The heater ribbon is no longer needed and therefore will not be included with this part. This kit works in the dispenser chute to let ice through when it is being dispensed. If you have the following symptoms such as: door sweating, difficulty opening or closing door, frost buildup, warm freezer section, or problems with ice dispensing, then this is a solution. The tools needed for this repair are a putty knife, needle nose pliers, and 1/4 inch nut driver. Wear work gloves to protect your hands when performing this repair.
Electronic Control Board – Part Number: W11629974
$265.04
In Stock
Electronic Control Board
★★★★★
★★★★★
(14)
Part #W11629974
When an ice maker is not making ice, its OEM ice level control board kit may be the part to check. The kit’s emitter and receiver use an infrared beam to sense the ice level in the bucket and signal the ice maker to make more.

Manuals & Care Guides for KSBP23INSS00

Click to download

Common Symptoms of the KSBP23INSS00

How this model fails, and the parts that fix it.

Watch our pros, then fix it yourself.

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
No ice
567 of 688 people found this instruction helpful.
  • Daniel from Suwanee, GA
  • Easy
  • 15 - 30 mins
  • Screw drivers, Socket set
removed flap door in front of icemaker...removed 3 screws with bolt heads...removed one additional screw with bolt head and ice unit slid out. I removed motor unit (pops out no screws). Replaced and had ice within 3 hours.
Was this helpful?
Thank you for voting!
there were directions
754 of 1282 people found this instruction helpful.
  • Kate from Jacksonville, FL
  • Very Difficult
  • 30 - 60 mins
We didn't know where the product went and it was very difficult to install.
Was this helpful?
Thank you for voting!
Ice maker stopped functioning
463 of 495 people found this instruction helpful.
  • Phil from Auberry, CA
  • A Bit Difficult
  • 15 - 30 mins
  • Nutdriver, Screw drivers
Remove the icemaker service door... gently pry the door pins from the hinge sockets. Remove the 3 screws from the under side of the icemaker with a nut driver (1/4"). Gently remove the icemaker . It's a tight fit between the top of the compartment and the icemaker lower support tray. Next, disconnect the electrical connector at the ri ght side. You're done! Reverse procedure for installing. Good luck. Remember, your working with cold plastic...take your time and don't force too much.
Was this helpful?
Thank you for voting!