KR720-AR (Type 1) Black and Decker Hammer Drill - Overview

This replacement screw is an authentic OEM sourced item, not an aftermarket equivalent. This is screw is used in a lot of different applications depending on your tool. Please check appropriate diagrams for correct use and location of this screw. This pan head screw is sold individually. You will need a torx screwdriver when working with this hardware.

It is a genuine replacement screw that is sourced directly from original equipment manufacturer. This is a standard hardware that has multiple uses depending your tool. For correct location and use of this screw, please check appropriate diagrams. This torx screw is sold individually.

This is a genuine DeWalt replacement part that has been sourced from the original manufacturer to be used with rotary hammers. The depth stop connects to the forward handle assembly and is used to limit the drill's bore depth. This item does not require tools to install and is sold as an individual replacement part.

This is carbon brush is sourced from the original manufacturer for use with DeWalt sanders, reciprocating saws, and hand saws. Brushes are considered wear items because the press against the rotating armature to supply the armature with electricity. Over time the brushes will wear down and need to be replaced. The brush includes the spring and is sold individually, please note two brushes are required.

This part is an OEM from Black and Decker for use with Hammer Drills. The chuck holds the bit in place. The most common reasons for replacing the chuck is if the drill bit is slipping inside the chuck, the jaws are worn or the Jaw is broken inside the chuck. This part is sold individually. The tools that you will need to replace the chuck is a screwdriver, large hex wrench, and a rubber mallet.