The charcoal filter, used in microwaves, removes food odors from the air. If your filter is damaged or you notice strong odors coming from your microwave, it is best to replace it. This part is metall...
This surface light bulb is used in ranges and microwaves. It has a high voltage of 12 and 10 watts. This bulb illuminates and directs light at the bottom of the microwave or the inside of it. It also ...
This part is a replacement glass cooking tray for your microwave. The cooking tray rotates when the microwave is running, and helps your food cook evenly. As it is made of glass, these glass cooking t...
If your microwave is not turning on it could be due to your fuse needing to be replaced. This part protects the microwave by shutting it off if there is an electrical surge. This fuse is just over an ...
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
July 31, 2021
Microwave intermittently beeps and display changes (when beeps)- how fix this?
For model number KHMS2050SSS0
Hello Nancy, Thank you for the great question. I recommend replacing the Part Number PS11745311. This board controls the function and the beeping you are hearing. When defective it will act as if the appliance is pressing its own buttons and will start on its own.Good luck with the repair!
Hello and thank you for writing.
error code F9. Q, means a communications error.
We suggest to try a hard reset:
Go to your breaker box and shut the breakers for your unit off, wait 5 minutes and then turn the breaker to on again. That should hopefully clear this problem. If this does not fix this problem then your control board PS11745306 might be faulty and possibly needs to be replaced. We hope this helps. Please contact us anytime.
There was no "fixing" per say but we still could not use the microwave without the plate. This has to be one of the biggest plates for a microwave. We ordered this through your company and we had it three days later. THREE DAYS! We had expected anywhere from 1-2 weeks. My husband was so impressed he bookmarked your site for future reference. Thank you for being so efficient and prompt. The glass turntable fit like a glove! Sincerely, Mark and Lia Hammond
Remove the filters and use a Torx driver to remove two screws holding the motor. The wires on on the motor are held in place by a plastic clamp that must be pried open on one side. That's all it takes to replace the drive motor. Everything else that makes the turntable spin lifts off from inside the microwave.
By pulling the filter screens units down and out with a pair of pliers I had access to the surface lights. Pulled the lights out of their sockets and replaced the bulbs. Real easy. Since the filter units were out, replaced the filters and reinstalled the filter units. The whole operation took less than 15 minutes.