KHDS750A (A2) Kawasaki Hedge Trimmer - Overview

The Breather allows air to enter the tank, so no vacuum is created as the fuel level drops, which would prevent the flow of fuel to the carburetor.It seals in the gas emissions and fuel at the same time. It is a metal and rubber part, sold individually, rated as "Easy" to install. If damaged, fuel may start leaking from it, and it must be...Read more replaced. The part is attached inside of the fuel cap. Refer to your make, model and diagrams to ensure you're choosing the right part.

The Fuel Tank Cap and Breather is an assembly made up of black plastic parts. You'll know if you need a new one if fuel is leaking, and this appears to be the source. This can happen due to normal wear, fatigue, and damage. This kit is rated as "Easy" to install and attaches to the fuel tank. Refer to your make, model and diagrams to ensure you're choosing the right part.

This fuel filter helps to ensure the fuel that goes into the engine is free of any contaminants. It is a genuine OEM sourced replacement part that is specially made for Kawasaki lawn and garden equipment. Filters over time may get clogged restricting the fuel flow, if this happens the filter would need to be replaced. This item consists of a metal frame with a felt filter material and it is sold individually.

This is an OEM part sourced directly from the manufacturer. The carburetor priming pump is found in Kawasaki backpack leaf blowers and small engines. This part is made of high-quality plastic, and is used to inject priming fuel into the carburetor. This item is provided as an individual replacement part.

This is a genuine OEM supplied replacement part that is designed for use with Kawasaki lawn and garden equipment. It is utilized to keep the fuel in the tank. It includes a retainer that remains in the tank to keep the fuel cap from being lost or falling on the ground. One durable plastic fuel cap is included per order.

This is an authentic item that is supplied by the original equipment manufacturer for use with Kawasaki engines commonly installed on lawn and garden equipment. It is one of the special diaphragms that ensure an air-tight seal in the carburetor, please make sure to refer the appropriate diagrams of your model for the correct location and ...Read moreapplication of this hardware. Unfortunately, over time gaskets and diaphragms tend to wear out and may begin to fail eventually requiring a replacement. Keep in mind this high-quality component is made of durable composite material and is sold individually.

This is a genuine part which is supplied directly by the original equipment manufacturer and is used with Kawasaki string trimmers. The recoil spring is coiled tightly into the starter housing. When the starter rope is pulled, the tension on the spring allows the rope to spin fast and send a spark to get the engine going. This part is mad...Read moree of metal and is sold individually. For installation you will need a screwdriver, this spring comes already coiled.

This is an authentic Kawasaki replacement part that has been sourced from the original manufacturer to be used with hedge trimmers. The metal guard is used to cover the cutting blades near the body of the trimmer. This item connects to the blade plate and a screwdriver and wrench may be needed to install this item. The blade guard is sold as an individual replacement part.

This is an original Kawasaki replacement part manufactured for use with hedge trimmers. The washer is commonly used to disperse pressure across a wider surface area that is applied to a part assembly by a nut or bolt. This washer is available as an individual replacement part, please see model diagram for associative parts.

An authentic OEM supplied replacement part that is specially produced for Kawasaki hedge trimmers and clippers. This is one of the nuts that is used to secure the plate and the cutters. Please note one durable metal nut is included per order.