KGCR025BAL1 KitchenAid Cooktop - Overview

This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch. It has 6 threads. Refer to the manual provided by the manufacturer for further information on repair and accurate guidance. Remember to wear work gloves as a safety precaution.

The knob skirt or grommet on your range goes around the knob, forming a buffer between it and the range surface. If your knob skirt is damaged, you should consider replacing it. This product is approximately 2 inches in diameter. This part is made of black plastic, and is sold individually. Many of our customers have described this repair...Read more as very easy. To complete the repair, simply remove the burner knob and the old knob skirt, replace it with the new knob skirt and re-attach the burner knob. The product contains four locking tabs that should snap into place easily.

This white knob skirt is located between the glass top and the control knobs of your stove top. The skirt has an outside diameter of approximately 2 inches. The most common reasons to replace the timer knob skirt is if it is cracked or damaged, or if the timer assembly will not advance. This repair is a relatively simple one, but be caref...Read moreul not to snap the plastic clips when you are inserting the new knob skirt into place. This genuine OEM replacement knob skirt is sold individually.

Metallic screw that is less than an inch long. Does not include the plastic washer.

This part is a black plastic knob that is most often used as a burner control knob. This knob allows you to turn the burner on your range or cooktop on, and it allows you to control the temperature of the burner. If your knob is broken, damaged, or lost, this is the replacement part you will need. This knob accepts a d-shaped shaft. To su...Read moreccessfully install this part, line the flat edge of the shaft up with the hole in the knob, then simply press the knob onto the shaft and into place. This knob is sold individually.

Sold individually. This knob can accept a D-shaped shaft.

This part helps your burner ignite and produce flame.

Sold individually. This knob takes a D-shaped shaft.

NOTE: No longer available in biscuit or white. Black only.

Part is located on top of the igniter switch that's next to the gas valve. Helps regulate gas flow and the amount of normal leakage that may occur.

This valve will automatically cut off the flow of gas when it reaches a certain pressure.