KERC607GWH0 KitchenAid Range - Overview

I removed the oven door by lifting it off with the hinges. Disassembled the door parts one at time making sure I remember where I removed the screws until I am able to get to the broken glass. The most difficult part is making sure that the insulation strip & the gasket stayed in place after I replaced the broken glass & doing the reverse ... Read more process of installing the parts together. Relatively easy process as long as you remember where the parts go. When in doubt, I had to refer to the pictorial of the disassembled door shown on your website.

First, layed tape across all broken glass to keep glass from shattering more and releasing more bits of glass. Pull up and out the oven door. Had table set aside covered with an old sheet to lay door on, After laying door on table, Removed outer screws. Needed phillips #2 & #3 tip widths and electric screwdriver, for inner screws that whe ... Read more re difficult to remove. Making notes of what came off first! ( (rt & left, bottom,/top) when removing metal frame braces, and in what order they go in when reassembled . Did the same with screws & set them aside in groups. Then marked the groups of screws. Removed the metal door panel. Carefully removed the in between panel of glass. Set Outer glass aside along with metal "door"and inner door glass,and proped them up in a safe place. Carefully removed the broken & shattered inside glass wearing rubber gloves. Had a garbage can next to the table to with news paper to wrap glass. Cleaned area. Replaced glass taking care not to tighted screws so much as to break the glass. Put added insulation.(Whcih was not the same as in diagram), around the edge. put back the inner glass panel, care not to leave prints, tighten screw ( care not to break glass) Cleaned the door sides and bottom, all had alot of grease buildup.
Put back the metal door portion. Cleaned the outer glass door front and back. Being careful not to break it (or leave prints inside). Replaced the side and bottom metal frames. Wiped it down and put door back on stove.

The easy part is removing the oven door and reinserting the oven door. Disassembly of the door was straight forward enough by removing the screws from the attached bottom plates. Separating the inner door from the out door was quite the pain. Once accomplished I was surprised to learn that the outer glass pane was not attached but free f ... Read more loating inside the door frame. Also the outside aluminum frame that the outer glass pane laid over was also unattached and free sliding in betwwen the inner and oute door. Getting this back into place then laying the free floating glass pane and keeping it positioned prior to re assembly of the inner and outter door was a tad nightmarish. The actual removal of the brackets to remove the inner broken glass plane was very easy. This is where a good drill or power screw driver comes in handy. Once the brackets holding the glass were removed, you take the broken glass out, put the new in, then reattach that glass pane with the brackets.Hat's off to those who did this whole project in 1/2 hr or less. It was a solid 2.5 hrs of time for me and my wife and I can't say that we drew closer together on this project. Actually a wall of separation started to develop between us until with God's help we finally got the whole door back together and in the oven. Be strong in the Lord and in the power of His might when you start to take on this project. Amen