KDPM604KBS1 Admiral Dishwasher - Instructions

I called an experienced plumber, who balanced and installed my new dishwasher properly, using the brackets I ordered from Parts Select, after an INEXPERIENCED plumber had tossed the factory-provided mounting brackets out with the shipping carton. Relief!

The valve has a plastic fitting to attach the the water line with a hose fitting. Was not carful enough with the original and damaged it attaching the water line. Ordered a replacement fitting. While it is possible to replace the water inlet valve without pulling the dishwasher out from the cabinet found it was easier to get at with the m ... Read more achine out. The video does and good job of showing the removal and replacing the valve. Easy job, don't be like me and be careful attaching the water line.

I found it best to lay the dishwasher on it's side, this makes it easier to attach a 90 degree hose fitting without cross threading the plastic fitting.

The old tine row came out easily and the new one was easy to pop into place. I was pleased that it was so easy to order a replacement part.

Removed old part and replaced with new part

At first I thought I needed a new bottom rack for my dishwasher. Out of curiosity, I watched the installation video and realized that the Tine Row installed separately and that was the only part I needed. I am appreciative of being able to access that video and the money I saved. Installation took seconds to complete.

Removed broken tin row. Replaced with new tine row. Tokk less than 1 minute.

Turn off water and disconnect water line.
Pull dishwasher out as far as possible.
loosen both door hinges, with a helper holding the door at an angle.
Disconnect connecting wire between hinges.
Remove and replace left door hinge. Then remove and replace the right hinge.
Reconnect every thing, turn on water.
... Read more Hinge is a poor design. Ours had grease on the spring and it had slipped off the connection.

There was no tools involved the part popped right into place. I received the part within two days from the date placed. It was great.

Cut DW brackets to size, attached to DW. Bent back tabs, pushed DW into place and installed screws.

followed directions, a kid could have done it,

Just replaced it in the notches that held the rusted tine.

quick and easy,tine-row just snapped right in! Took about 15 seconds!

I just popped the new one onto the bottom of the middle rack and it was done. Easiest repair I have EVER done!

repair by replacement