KD3 - Overview

This is a splash guard and stopper for a garbage disposer. The splash guard is a rubber cover that goes over the sink drain to prevent liquids and food particles from splashing back up into the sink while the garbage disposer is running. The stopper creates a seal on the splash guard and prevents liquids and food from going down the drain...Read more when the garbage disposer is not in use. With normal wear and tear of these parts, they will eventually need to be replaced. Both parts are black in color and approximately 3 inches in diameter, with the splash guard being slightly larger so the stopper can fit inside of it.

Steady moisture control depends on a working humidity sensor. A damaged sensor may cause the dehumidifier to run too long, stop too soon, or show the wrong humidity level. First check the room temperature, air filter, airflow, and control settings. Confirm the replacement with the complete appliance model number. Disconnect power and empt...Read morey the water bucket before service. Handle the sensor and wires gently. If the readings remain incorrect after replacement, the control board may need testing.

If the handle on your dehumidifier’s water tank feels loose is cracked or shows signs of wear replacing it can help restore safe and convenient use. This replacement handle is designed for a secure fit making it easier to remove and carry the water tank without risk of damage or spills. It’s an essential component for maintaining the func...Read moretionality and ease of use of your dehumidifier. Please verify your device’s model number before purchasing to ensure compatibility.