KCDI250X3 KitchenAid Food Waste Disposer - Overview

The splash guard, also known as a mounting gasket, is used for garbage disposals. The splash guard creates a watertight seal between the sink flange and the garbage disposal ring. The rubber cover covers the top of the sink drain and it opens in the center to allow water and food particles into the garbage disposal while keeping liquids a...Read morend food from splashing out or back into the sink. This should fix any issue or symptom of garbage coming back out of your sink. Refer to the manufacturer-approved instructional diagram for installation and accurate guidance.

Sold Individually.

This is a sink flange gasket that is designed for use within various models of sinks and is installed between the strainer and garbage disposal. Made of rubber and measuring approximately 4.5-inches in outer-diameter, this seal can become damaged or worn over time and through extended use can lead to leaks from the disposal, at which time...Read more it will need replacing. This seal is sold individually, and because there are two seals in the gasket, you may need to consider acquiring multiple. When replacing this flange gasket, you will likely need a screwdriver and wrench to gain access to the pipes holding this seal. It is important that you disconnect the power and water supply before doing any repairs.

Also known as a tailpipe gasket.

This is a tailpipe, but you may also know it as a drain pipe, and it is compatible with your garbage disposal. The most common reason for needed to replace this part is if it is damaged and leaking. This piece measures about 5 inches long, 3 inches high, and 2 inches wide, and it is black in color. The purpose of this piece is to aid with...Read more the drainage in your garbage disposal plumbing unit. If your tailpipe is damaged this is the OEM replacement part you will need.

This inner stopper gasket, also known as a splash guard gasket, is an authentic manufacturer replacement part used in food waste disposers. It is a rubber gasket positioned around the perimeter of the inner stopper. It seals the area between the stopper and the disposal housing to prevent water and food waste from leaking out during opera...Read moretion. Over time, the inner stopper gasket may tear, or wear down, impacting its ability to contain water and waste. If the inner stopper gasket fails, water will leak from the unit and damage the surrounding area. The disposer may also be unable to adequately grind waste, leading to clogging and damage. To replace the gasket, twist the inner stopper out of the unit and peel the gasket off. Clean the sealing surface and place the new gasket on to the stopper. Reinsert the inner stopper back into the unit.

This bolt measures 1/4 inch in diameter with a thread count of 20 per inch and a length of 5/8 inch. It holds different parts of your kitchen appliance together, such as panels or handles, to ensure structural integrity. If the bolt is rusted or stripped, parts of your appliance will feel wobbly. Loose or missing bolts can cause the parts...Read more they are holding to detach. Use a wrench to remove any bolts that you need to replace. Take note that this OEM component is sold individually, so consult your user manual to determine the number of bolts your machine needs. Consider purchasing extra bolts if you are replacing one, as these bolts typically wear out at the same time.