KCBC150X0 KitchenAid Food Waste Disposer - Overview

This is a sink flange gasket that is designed for use within various models of sinks and is installed between the strainer and garbage disposal. Made of rubber and measuring approximately 4.5-inches in outer-diameter, this seal can become damaged or worn over time and through extended use can lead to leaks from the disposal, at which time...Read more it will need replacing. This seal is sold individually, and because there are two seals in the gasket, you may need to consider acquiring multiple. When replacing this flange gasket, you will likely need a screwdriver and wrench to gain access to the pipes holding this seal. It is important that you disconnect the power and water supply before doing any repairs.

This is a black flexible rubber cover that is over the top of the sink drain, used for your food waste disposer. It keeps liquids and smaller food particles from splashing back into the sink. The splash guard can become worn out over time and may need to be replaced. Make sure to disconnect the power before beginning your repair. This par...Read moret is 3.75 inches in length, 3.75 inches in width, 0.75 inches in height and weighs 0.119 lbs. Remove the drain pipe from the disposal, and turn the mounting ring. Remove the old cover with a screwdriver and place the new one into place.

The stopper, also known as a splash guard, is located over the top of a sink drain and garbage disposal unit. With a hole in the center, the stopper will allow water and food items to go into garbage disposal while keeping liquids and smaller food particles from splashing back up into the sink. It is normal for this part to wear out event...Read moreually from use, but it is important to replace if you notice garbage coming up to the surface of your sink. The stopper is a flexible rubber cover and it comes in black. Refer to the manufacturer-approved installation diagram for further instruction.

Also known as a tailpipe gasket.

This is a tailpipe, but you may also know it as a drain pipe, and it is compatible with your garbage disposal. The most common reason for needed to replace this part is if it is damaged and leaking. This piece measures about 5 inches long, 3 inches high, and 2 inches wide, and it is black in color. The purpose of this piece is to aid with...Read more the drainage in your garbage disposal plumbing unit. If your tailpipe is damaged this is the OEM replacement part you will need.

This bolt measures 1/4 inch in diameter with a thread count of 20 per inch and a length of 5/8 inch. It holds different parts of your kitchen appliance together, such as panels or handles, to ensure structural integrity. If the bolt is rusted or stripped, parts of your appliance will feel wobbly. Loose or missing bolts can cause the parts...Read more they are holding to detach. Use a wrench to remove any bolts that you need to replace. Take note that this OEM component is sold individually, so consult your user manual to determine the number of bolts your machine needs. Consider purchasing extra bolts if you are replacing one, as these bolts typically wear out at the same time.

Sold individually.