K5H Compressor - Overview

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Jenny equipment. This is an identical replacement for a missing or damaged bearing-rod that was originally installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and applicatio...Read moren of this hardware. Keep in mind this high-quality item is made of durable metal and is sold individually.

This genuine manufacturer sourced gauge is designed for use with Jenny air compressors. The gauge registers pressure readings and allows you to maintain needed pressure. It provides an identical replacement for a damaged or a missing component that was installed on a new unit. Note, this high-quality gauge is sold as an individual item. Y...Read moreou would need a wrench to secure this gauge to the manifold. When replacing this item make sure to unplug the air compressor and bleed out air from the tank.

This is an original DeWalt replacement part, not an aftermarket imitation. The gasket is manufactured for use with air compressors. This special gasket is used to seal the connection between the valve plate and the cylinder. It is recommended to replace gaskets when servicing the air compressor to ensure proper seals when the parts are re...Read moreassembled. This gasket is available as an individual replacement part, please see model diagram for associative parts.

It is an authentic manufacturer sourced replacement gasket which is designed for DeWALT air compressors. This carburetor gasket provides an air-tight seal between the cylinder head, please make sure to refer to appropriate diagrams of your model for the correct location and use of this hardware. Over time gaskets tend to wear out and may ...Read morecrack eventually requiring a replacement to maintain peak performance. It is made of high-quality composite material and it is sold individually.

It is an OEM component which is designed for use with air compressors. This special nut sleeve assembly secures the pressure relief tube to the pressure switch. It is a high-quality replacement for a damaged or a missing hardware that was installed on a new unit. One durable metal nut sleeve assembly is included. A wrench will be needed t...Read moreo perform this repair. Check the appropriate diagrams for your model to ensure the proper replacement procedure. Make sure to drain the air before starting this repair.

This replacement screw is a genuine OEM sourced item commonly utilized on air compressors and pressure washers. It is a standard hardware which has multiple applications depending on the unit. Please make sure to check diagrams of your model for the correct location and used of this screw. This part is made from durable metal and it is sold individually. You will need a wrench to install or remove this hardware.

This is a genuine Jenny replacement part for use in compressors. The rubber pad attaches the portable dual tank. A hammer may be needed during the replacement of this part. It will need to be replaced if it breaks. This item is sold individually.

It is an authentic Jenny part which is supplied by the original equipment manufacturer for use with portable air compressors. The valve-pilot has a hand toggle unloader for easy starting. Factory preset yet can be adjusted for higher or lower pressures. Keep the compression fitting from your old one, and replace your old pilot valve with ...Read morea new one. Check the owner's manual and the parts diagrams to ensure the correct repair procedure. Note, this high-quality valve-pilot is made of durable metal and is sold individually.

This is an authentic Jenny replacement part that has been sourced from the original manufacturer to ensure quality. The metal petcock drain is intended to be used with air compressors. This part attaches to the tank and is used to drain the tank's contents. This part may require a wrench to install and the petcock is sold individually.