K1A-17P-CRC-SW3 Jenny Compressor - Overview

This is an OEM replacement part for Jenny portable electric single stage compressors. The cord plugs into the wall and then into the compressor, and transfers electricity to power the machine. This part is made of flexible plastic and metal, it is also sold individually. For installation, you will need a screwdriver and a pair of needle nose pliers. Be sure to unplug the machine before starting this repair.

This is a genuine Jenny replacement part for use in compressors. The rubber pad attaches the portable dual tank. A hammer may be needed during the replacement of this part. It will need to be replaced if it breaks. This item is sold individually.

It is an authentic Jenny part which is supplied by the original equipment manufacturer for use with portable air compressors. The valve-pilot has a hand toggle unloader for easy starting. Factory preset yet can be adjusted for higher or lower pressures. Keep the compression fitting from your old one, and replace your old pilot valve with ...Read morea new one. Check the owner's manual and the parts diagrams to ensure the correct repair procedure. Note, this high-quality valve-pilot is made of durable metal and is sold individually.

This is an authentic Jenny replacement part that has been sourced from the original manufacturer to ensure quality. The metal petcock drain is intended to be used with air compressors. This part attaches to the tank and is used to drain the tank's contents. This part may require a wrench to install and the petcock is sold individually.

Keep in mind that this part is made of metal and is sold individually. The aftercooler-hose attaches to the male connector. A set of pliers may be helpful when replacing this item. This part will need to be replaced if it breaks. It is an authentic OEM sourced item which is specially produced for use with Jenny compressors.

This is available as an individual replacement part. The filter encases the element-filter and is made of metal and plastic. If this part becomes broken it will need to be replaced and may require a wrench during the installation. This is an OEM Jenny part directly sourced from the manufacturer for use in stroke pumps and compressors.