K181-13806 Kohler Engine - Overview

This item is available as an individual replacement part. The retainer attaches to the intake valve and the exhaust valve. A set of pliers might be needed during the installation process. It is made of metal and will need to be replaced if it becomes broken. This is an authentic OEM sourced item which is specially produced for use with Kohler engines and generators.

This breather filter in your lawn and garden equipment traps contaminants in the breather system to prevent them from entering the engine. As the filter ages, it can become clogged or dirty, restricting airflow and leading to issues like poor engine performance, increased pressure inside the engine, and higher oil consumption. Regular rep...Read morelacement is necessary. To remove the filter, consult your user manual for instructions. Typically, you will need to access the breather assembly and remove any covers or components, like the breather hose and upper cylinder valve cover. Then, simply pull out the old filter. Please note that this OEM replacement breather filter is purchased individually.

A genuine item that is supplied directly from the original equipment manufacturer for use with Kohler generators. It is a high-quality gasket that is utilized to provide an air-tight seal for the valve cover, over time the material may get compressed or begin to crack eventually requiring a replacement. Make sure to refer to the appropria...Read morete diagrams of your model for the correct location and application of this component. Keep in mind this durable part is made of high-quality composite material and is sold individually.

This is an authentic replacement part manufactured for use with Kohler small engines. The bowl gasket is used to seal the connection between the carburetor body and the float bowl. It is recommended to replace gaskets when servicing or rebuilding the carburetor to ensure good seals when the parts are reassembled. This bowl gasket is available as an individual replacement part.

An authentic component which is supplied directly from the original equipment manufacturer for use with Kohler engines commonly installed on lawn and garden equipment. It is a high-quality replacement for a missing or worn gasket that helps to provide an air-tight seal for the carburetor, please refer to the appropriate diagrams of your m...Read moreodel for the correct location and application of this hardware. Keep in mind the gasket is made of durable composite material and is sold individually.

This part is an OEM from Kohler for use in engines and generators. The gasket head attaches to the cylinder head and is made of a thin material. It may require a wrench during the installation. Over time this item may break and will need to be replaced. This item is available as an individual replacement part.

This breather seal, also known as a breather vent or plug, is used within the engines of various power equipment models. It is used to regulate pressure, protect against dirt, debris and excess moisture, and extend the overall life of the engine it is in. Measuring 1-inch long and approximately 0.5-inches in outer-diameter, this breather seal is a part from the original equipment manufacturer.?

Kit, float repair

This valve rotator fits beneath the valve spring and gently turns the valve during engine operation, helping promote even seat wear, better sealing, and improved heat dissipation. By preventing carbon buildup and localized hot spots, it supports smoother valve action and longer engine life. Commonly replaced during top-end service or rebu...Read moreilds, this component is especially important when addressing compression loss, valve leakage, or uneven valve wear in small engines used on lawn and garden equipment.

The bowl retainer screw gasket attaches to the fuel bowl. This is an OEM Kohler part directly sourced from the manufacturer for use in engines and generators. The item is sold individually and is made out of a thin material. A screwdriver, a set of pliers, a wrench set, and a nutdriver might all be needed during the installation process. It will need to be replaced if it breaks.