This is the replacement charcoal filter for your microwave. It is silver and black in color and measures approximately 10 inches by 2 ½ inches. The charcoal filter removes cooking odors from the air ...
This is a genuine replacement 40 watt bulb for a microwave. The bulb is meant to light up the underside of the microwave or inside of your microwave when the door is open or during use. If your bulb i...
This light socket is for your microwave and is designed to hold the light bulb. If the light bulb is not working, and the bulb has not burned out, it may be a problem with the light socket. This part ...
This turntable tray is for microwaves.
Turntable tray rotates in the center of the microwave to help ensure the food cooks evenly.
Follow the instructions in the owner's manual when installing this part.
Ask our experts a question about this model and we'll get back to you as soon as possible!
5 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Richard
August 10, 2023
The fan has lost power to move the smoke into vents instead of the room.
Sets off smoke alarms.
For model number JVM3160DF2CC
Hi Richard, thank you for your inquiry. A buildup of grease, food particles, or other debris inside the microwave can impede the airflow and cause smoke to accumulate. Regularly clean the interior of the microwave, the turntable, and the filters or screens. Ensure that the vents or ducts leading from the microwave to the outside are clear and not blocked by any obstructions. This will allow the exhaust fan to expel smoke effectively. If all checks are fine, we recommend replacing the fan motor, part number PS8754500. We hope this information is useful!
Everything works exself want heat wart or cook food
For model number JVM3160DF2CC
Hello Clayton, thank you for your question. That issue is usually caused by a faulty, diode, door switch, capacitor or magentron. We would recommend testing those parts first. I hope this helps.
Hi Jim,
Thank you for your question. If your microwave will not turn on, there are some parts that you will need to check to see which one is causing the issue. You will need to check the microwave fan thermostat, the microwave fuse, the thermostat, the door switches, the light socket and the door latch. We hope this helps! Good luck with the repair!
Open the front cover by pushing it at the top (where it says “Push”), lifting up and pushing back on top edge of the old filter. Pull it out. Installing the new one is basically just the reverse of those steps! That simple.
Old filter did seem to be a little thicker (filter material), but the new one was the exact same dimen
... Read moresions, so it went in properly. Wish the filter material was white, so you knew just how dirty it was actually getting. But... :-D
1. Unplug unit 2. Open door, remove two screws above the top trim piece, slide and remove trim. 3. Remove screw behind control board and top left corner, then release from position. 3b. Unplug all wire terminations and set control panel aside. 4. Remove two screws securing latch board, lift and rotate board
... Read moreout of position, remove three micro switches, xfer monitor switch actuator from lower pin in old board and insert in new. Install new door switches and reverse procedure to complete repair.
Note 1. Take care to located new latch board so holding tabs line up, pass through frame, and openings for door tangs line up with openings in frame before securing with screws.