JP81*03 General Electric Range - Overview

Diagrams for JP81*03

See every part. Know exactly what you need.

Parts for the JP81*03

$56.93

Tilt Lock Hinge Mounted Surface Burner Kit - 6"

★★★★★

(1)

Part #WB30X342

This 6-inch surface element provides heat for boiling, frying, and simmering on an electric range. Its 3-wire, tilt-lock design runs on 240 volts and produces about 1,325 watts. Replace it if it does not heat, heats unevenly, or has burned or broken areas. Before ordering, inspect the control switch, wire ends, and mounting parts. Confirm...Read more

Read less

$63.61

Tilt Lock Hinge Mounted Surface Burner Kit - 8 Inch

★★★★★

(2)

Part #WB30X341

This tilt lock hinge mounted surface element kit includes an 8 inch element, three wire, 2450 watt surface element, and a terminal block with all three-wire units. These high rise elements do not come with an attached trim ring.

$40.02

RANGE RED LENS/JEWEL

Part #WB25X65

$160.30

Switch

Part #WB23X33

$27.36

NEON LAMP

Part #WB2X3468

Common Symptoms of the JP81*03

How this model fails, and the parts that fix it.

Element will not heat

Fixed by
these parts

Show All

Repair Tips From Fixers Like You

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Old large 8" stove burner had burnt out, needed replace

7 of 7 people found this instruction helpful.

Stephen from GOFFSTOWN, NH
Really Easy
Less than 15 mins
Nutdriver, Pliers, Screw drivers

Simply took the replacement part ( PS244040, GE WB30X341) and did the quick direct swap using all the new pieces in the burner kit. UNPLUG the stove. Undo the titl arm screw, remove the plastic wire isolation block (2 spring clips), unscrew the 3 wires to the elements, screw the 3 wires to the new element, put in new bakelite wire isolati ... Read more

Read less

Was this helpful?

The instructions on striping the wires was slightly confusing.

Katherine from Berkeley, CA
A Bit Difficult
15 - 30 mins
Screw drivers, Wrench set

I stripped one wire on the first burner. Then I realized that the terminals were the ones that could be left. Finding a replacement terminal has proved to be difficult. Once I realized my mistake I could change the other three burners very easily.

Other Parts Used:

Tilt Lock Hinge Mounted Surface Burner Kit - 6"

Tilt Lock Hinge Mounted Surface Burner Kit - 8 Inch

Was this helpful?

only half of burner working

KENNEDY from OCEAN GROVE, NJ
A Bit Difficult
30 - 60 mins
Screw drivers, Socket set

Replaced the old with the new following directions (mostly).

Was this helpful?