JN1601 Makita Nibbler & Shears - Overview

Length 8 Foot Length: 6' Gauge: 18 Wires: 2 Type: Bare Wire This power supply cord is a genuine OEM sourced replacement part. It is specially made to supply power from a standard outlet to Makita power tools. A cracked or damaged cord should be replaced before continuing to use the tool. This rubber insulated cord is sold individ...Read moreually. It comes with a rubber sleeve grommet that is not sold separately. Replacing this power supply cord you will need a screwdriver. • Remove the housing screws • Remove the the housing • Disconnect the old cord wires • Remove the old power cord • Secure the new cord in place • Connect the wires • Reassemble and test the new cord

This #191938-1 (CB-408) Makita carbon brush set contains two individual carbon brushes with wire leads and brush springs attached. The set contains genuine Makita replacement parts, and comes packaged in a Makita retail box. This brush set will fit the Makita tools listed at the bottom of the page. • Worn brushes are often the cause...Read more of a poorly running motor • Replacing brushes can fix an intermittent motor • New brushes can restore a motor's electric braking Carbon motor brushes are one of the most commonly replaced power tool components. Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement. Worn brushes are common causes of intermittent motor function, reduced electric braking, and reduced motor power. A worn out brush will often be worn down near the wire lead and may be cracked, pitted, or burned. When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem.

Genuine Manufacturer Sourced replacement part used on a variety of Makita Power Tools. This is a Metal Pan-Head Screw and it is sold individually. This screws is commonly used to hold two pieces of Housing Set together.

Genuine Makita replacement part, this part is sold individually. This screw is used to secure various internal and external parts in the tool models shown below. This is a pan-head phillips tapping screw.

This authentic OEM part is compatible with various handheld power tools made by Makita including jig saws, routers, and sanders. A bearing\\\'s main purpose is to decrease friction between moving parts. They also stabilize parts to keep proper direction and angle. Bearings are high wear items that may need regular replacement. Sold individually. Included in part number 517266-0 Armature Assembly 115V

• This cord guard is a genuine Makita replacement part and is sold individually. • Cord guards, also called cord protectors, are designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard. ...Read more • This cord guard will fit cords for the tools listed under the "Compatible Tools" listing. It is not guaranteed to fit any other cords.

This manufacturer sourced replacement pin is made out rubber and it is sold individually. It acts as a cushion/spacer in a variety of Makita power tools. This is a standard piece of hardware and it has multiple applications based on your tool. Please refer to diagrams for correct application.

This genuine OEM die is designed for use with nibblers. It works with the punch to cut sheet metal by providing a stable punching base and allowing for consistent cut sizes and shapes. A faulty die can result in rough or incomplete cuts, bent materials, slower performance, and equipment jamming. To replace the die, first ensure the nibbl...Read moreer is turned off and unplugged from any power source. Remove the nibbler protective casing/housing to access the die. Use a wrench or screwdriver to remove the fasteners holding the die in place and lift the die out of the nibbler. Place the new die in the correct position and reattach the fasteners to secure the die in place. Switch the nibbler on and use a piece of scrap metal to check that the die is functional and can create clean cuts.