This is a replacement drip bowl for your range or oven. The drip bowl sits beneath the burner element and collects any drips or spills. This drip bowl is 8 inches in diameter and is used to replace the large burner drip bowl. This bowl is white on the top and black on the bottom. It is sold individually and is an OEM part from the manufacturer.
This is foam tape and it is usually used in conjunction with your range, specifically on the cooktop. Its purpose is to help seal the edges of the cook top to the counter top. Another of its functions arises is if your cooktop does not sit properly. This tape can give it a better fit by adding additional stability. It is black in color an...Read mored can be used for gasketing, sealing, and stopping vibration. Before making this repair, make sure to shut off the circuit breaker for your appliance in order to disconnect electrical power.
This comes set from the manufacturer for Natural Gas. It also includes the conversion to Liquid Propane.
This valve automatically cuts off the flow of gas at a certain pressure.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Burner igniter needed to be replaced
37 of 63 peoplefound this instruction helpful.
Thomas from Bloomsbury, NJ
Easy
15 - 30 mins
Screw drivers
Assumed the entire top of the range would have to be lifted off. Removed the three screws inside the top of the over door and then noticed the two screws holding the dish around the burner. They were tight and required WD-40 and then a sharp tap and came off. Important: Notice the direction your old igniter is plugged into the w
... Read moreire. It is not clear and can go on either way.
Read less
Was this helpful?
Thank you for voting!
Drip pans needed to be replaced.
18 of 26 peoplefound this instruction helpful.
Steve from Broken Arrow, OK
Really Easy
Less than 15 mins
Screw drivers
Simiple repair. Determined drip pan size (sm, med., lg.) removed 2 screws holding drip pan, placed gasket around new drip pan and installed. Repaired took less than 5 minutes.
Was this helpful?
Thank you for voting!
The porcelain had chipped on the burner bowls
14 of 17 peoplefound this instruction helpful.
Paula from Seal Beach, CA
Really Easy
15 - 30 mins
Pliers, Screw drivers
Removed the two screws holding the porcelain burner bowl. Disconected the electric igniter by removing the "w" clip on the underside of the bowl. Then disconnected the igniter from the electric supply cord. Reverse these directions using the new urner bowl. Really easy.