JGBP30BEW1AD General Electric Range - Overview

Hi James, thank you for the question. We would recommend checking the oven igniter, part number PS243425, to fix the issue. Follow these step-by-step instructions for replacing the igniter: 1. Disconnect Appliance from Power Source. 2. Open the door and remove the racks. 3. Remove the bottom panel. 4. Disconnect the wire that connects the wire to the components inside the range. You do this by closing the range door and removing the bottom drawer. 5. Disconnect the wire by pulling it out of the clip and remove the 2 screws 6. Open up the door and remove the screw that holds the manifold pipe, then turn the pipe so you can remove the screws that hold the pipe 7. Remove old igniter and cut both ends. 8. Take the ending clips of the old igniter and strip them down, take the ends of the wires and tie them together, then put the wire nut on each end. 9. Position new igniter on manifold pipe. 10. Replace the 2 screws to screw the igniter into the manifold pipe, then screw the manifold pipe back into the base of the range. 11. Connect wires back into the unit, connect the wires back into the safety belt. 12. Put the 2 screws back you took out previously. 13. Put the bottom drawer, the bottom panel (put screws back in), and racks into the range, close the door. Good luck with your repair!