Models
>
JE940PV03
JE940PV03 General Electric Microwave - Overview
Sections of the JE940PV03
[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".
Cooking Tray
PartSelect #: PS248248
Manufacturer #: WB39X10003
This is a cooking tray and it is a common component in any microwave. This piece is transparent and is made of glass. The diameter of this part measures to be roughly 12.5 inches. Although you may fin...
$115.25
In Stock
Secondary Door Switch
PartSelect #: PS237421
Manufacturer #: WB24X829
The secondary door switch is a simple on/off mechanism that stops the microwave from operating when the door is open (normally opened). The switch monitors the door latch position, and communicates w...
$45.34
In Stock
Monitor Door Switch
PartSelect #: PS237422
Manufacturer #: WB24X830
Unplug your microwave before attempting this repair. You will need to remove the grill, which is held into place by two screws at the top of the grill (open your microwave door before doing this). Rem...
$37.02
In Stock
High Voltage Diode
PartSelect #: PS239843
Manufacturer #: WB27X1160
This diode has a 1/4" female connection and an eyelet.
$123.73
In Stock
Magnetron
PartSelect #: PS239727
Manufacturer #: WB27X10585
This part is used to generate microwave energy/heat.
$182.67
Special Order
Turntable Motor
PartSelect #: PS237905
Manufacturer #: WB26X172
This motor rotates the glass turntable in the microwave.
$105.96
In Stock
Questions And Answers for JE940PV03
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the JE940PV03
[Viewing 5 of 5]Doesn’t shut off
Fixed by
these parts
these parts
Show All
Won’t turn on
Fixed by
these parts
these parts
Show All
No heat
Fixed by
these parts
these parts
Show All
Touchpad does not respond
Fixed by
these parts
these parts
Show All
Tray won’t turn
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
A Cooking Tray developing a growing crack
The unbelievable happened. Our glass carousel cooking tray developed a crack. Each day the crack got longer. I ordered a new one on Tuesday and it arrived the next morning just before the cracked one completely cracked. I have never experienced such fast service. I highly recommend PartSelect and their helpful service.
Parts Used:
-
Ruth from New Bern, NC
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
474 of 479 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
plate broke
-
craig from lindenhurst, NY
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
462 of 553 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
light worked, timer and control pad worked, but no turntable, no heat, no noises of any sort, just didn't start up
Noted on partselect.com that someone else with this problem, found it to be secondary door switch. There are three door switches in this model, but online info noted that one of the three might feel "soft" (in my case, one switch clicked in a rather "jiggly" way, the other two were strong decisive clicks.) To access the door switches on
... Read more
this model was the only difficult part. First use a torx bit to remove the two torx screws below the latches inside the microwave. This frees the latching part inside, that holds the door switches, which you will remove after you take off the control panel. The top grill has to come off before you can remove the door panel. Remove the screws above the grill, on the microwave top cover, The grill on this model is covered with a panel that moves out when it vents. After removing the two top screws, the covered grill vent slides left to remove. Be careful, as the sliding tabs are plastic. Wiggle and jiggle it, to slip it off. Below the removed grill, is a small metal grill with one screw in lower center. Remove that screw, and wiggle that out. You'll then see the one screw that holds on the control panel. Remove this screw, and lift the control panel up to remove. Again, go slowly and gently, as the bottom tabs holding the control panel in, are also plastic and easily broken. Lay the control panel on something, (I used the coffee maker) and pull out the wire bundles tucked on the left, that are attached to the latching panel. Wiggle the latching panel gently to lift it up off of it's plastic tabs and pull it out towards you, so you can see the three door switches. Each switch (part number WB24X829) has a little black switch on it. Feel each switch with either your finger, or a screwdriver to see which one doesn't "click" strongly. The weak one is the one you will replace. The door switches are fitted into a tab, and plugged into their wires. Remove the defective switch, pull out the wires, and replace it with the new switch, plugging back the wires, and slipping it back into it's plastic tabs. Then put everything back together in reverse order. The entire job took me fifteen minutes EXCEPT for figuring out how to slide off the upper grill, which I have told you. A repairman would have cost $150, the part was $18. AND, there's a good chance, the other two switches will get "used up" in the next year or so as well, so I'll be ready next time. Thank you, Partselect, why work all day, to make money, only to give it to somebody else, for fifteen minutes of work. All I needed was the knowledge.
Read less
Parts Used:
-
Marla from Arlington, TX
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
310 of 369 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!