Quick Question!

Have you ever purchased from PartSelect.com before?

Models > JE1590SC01

JE1590SC01 General Electric Microwave - Overview

Get Parts and Repair Help for JE1590SC01

If you know the microwave repair part you need, you can browse the list of all parts on the JE1590SC01, or you can search by name or part description. You can also find your part by where it is located on the JE1590SC01 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the JE1590SC01

[Viewing 1 of 1]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Line Fuse

This ceramic microwave fuse is just over an inch in length. It is white in the center, and metal on both ends. This is a 20-amp fuse, and is used to power your microwave. If the to...


Glass Cooking Tray

There are two different couplers (also known as a turntable shaft) that can be used for this tray - a male D-shaped shaft and a female D-shaped shaft. The couplers are sold separately.


Primary Door Interlock Switch

This interlock switch is located in the door latch.


Oven Lamp


Door Latch

Used to keep the microwave door closed during operation.


Monitor Switch



This part will trip once the inside of the cavity overheats and exceeds the recommended temperature.




Turntable Guide With Rollers

This roller guide sits underneath the glass turntable tray.


Diode Cable

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Microwave completely stopped working

  • Customer: Kim from Cliffside Park, NJ
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 739 of 968 people found this instruction helpful
Turned out the issue was easily solved by replacing a single, inexpensive fuse.


The fuse is located under the plastic grill at the top of the microwave. It's held on by two screws. Once you've removed the screws and taken off the plastic grill, you go to the right side of the microwave and remove an... read more

Bulb Replacement

  • Customer: Donald from San Marcos, CA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 37 of 40 people found this instruction helpful
Remove shroud . Two black philips head screws on side, and several on the back side. The two bottom screws on the back are special screws that a philips,straight slot, or hex screwdriver will not remove. I took a dremel tool with a thin metal grinding disc and created a straight slot through the centr of the two bottom screws. This allowed their removal with... read more

No power to microwave, no heating.

  • Customer: Michael from Coulterville, CA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 44 of 71 people found this instruction helpful
Unpluged power cord!! Removed front control panel to expose electronics (need to remove top horizontal vent cover to expose mounting hardware). Unplugged leads to control panel board. Removed magnetron with Tstat (3- phillip heads, need stubby). Installed new parts and control panel, plugged it in tested. Done. read more