J-7554 (Type 2) Porter Cable Boring Machine - Overview

Genuine OEM Replacement Part used on a variety of Power Equipment. This part is made out of Metal and is Sold Individually. Terminal Eyelet allows you to safely and easily secure a wire to the needed part of the tool using only a screw.

This is a genuine Porter Cable replacement part, it is sold individually. A Cord Strain Reliever is used on most all power tools. It purpose is to reduce the bending of the cord as it comes out of the housing, which otherwise would cause the cord to crack and wear.

Genuine OEM sourced replacement part used on a variety of power tools. Ball bearings are used to reduce friction between rotating parts. Bearings experience constant wear when the tool is in operation, because of this they need to be periodically checked and replaced if needed. This part is made out of metal and it is sold individually. Included in part number 381004-00 spindle assembly.

This is an OEM part sourced directly from the manufacturer. The screw is designed for use in drills, sanders, and saws. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are different screws used in the machine. Refer to the parts diagram to be sure of orde...Read morering the correct part. You will require a screwdriver when replacing this part. This item is sold individually.

This is an original part from Porter Cable for use with Drills. The chuck holds the bit in place. The most common reasons for replacing the chuck is if the drill bits are slipping or falling out of the chuck, the chuck won't open or close, the chuck jaws (teeth) are damaged, the chuck seized onto the spindle or the chuck is difficult to r...Read moreotate. This part is sold individually. The tools that you will need to replace the chuck is a Torx driver (#20), large Allen wrench and a hammer.

This is an authentic Porter Cable replacement part that has been sourced from the original manufacturer to be used with drills. The chuck key is used to provide leverage to open and close the chuck when changing drill bits. The chuck is available as an individual replacement part, please see illustrated diagram for associative parts.

This cord is a genuine Porter Cable replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. rnPower Cord Specifications: rn • 2 Prongs rn • 2 Wires rn • 16 Gauge rn • 10 Feet Long

This Ball Bearing has metal shielding on both sides. This is a genuine Porter Cable replacement part that is sold individually. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This ...Read morereduces wear on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

Genuine Porter Cable replacement part This brush is sold individually, 2 are needed for the tools shown below It is always best to replace both brushes, even if only one is worn. Worn brushes frequently are the cause behind a motor running poorly. Replacing brushes can fix a motor that's operating intermittently. New brushes can rest...Read moreore a motor's electric braking. Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

This is a genuine Porter Cable product sourced from the original manufacturer, not an aftermarket imitation. The tube of grease is 5.5 ounces, and is used to lubricate various kinds of equipment, and power tools. This tube of grease is sold individually, please see model diagram for compatibility, and usage.