J-346 (Type 1) Porter Cable Circular Saw - Overview

Genuine OEM Replacement Part used on a variety of Power Equipment. This part is made out of Metal and is Sold Individually. Terminal Eyelet allows you to safely and easily secure a wire to the needed part of the tool using only a screw.

This brush is a genuine Porter-Cable replacement part, not generic. As pictured, this brush is ready to install and includes carbon brush, wire lead, and spring. This item is sold individually. Over time, brushes will wear down and eventually require replacement. This brush will fit the models listed in the 'Compatibility' section belo...Read morew. It is not guaranteed to fit any other power tool models. • Worn brushes are often the cause of a poorly running motor • Replacing brushes can fix an intermittent motor • New brushes can restore a motor’s electric braking Carbon motor brushes are one of the most commonly replaced power tool components. Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement. Worn brushes are common causes of intermittent motor function, reduced electric braking, and reduced motor power. A worn out brush will often be worn down near the wire lead and may be cracked, pitted, or burned. When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem.

This cord is a genuine Porter Cable replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. rnPower Cord Specifications: rn • 3 Prongs rn • 3 Wires rn • 16 Gauge rn • 7 Feet Long

It is a genuine item that is supplied by the original manufacturer for use with Porter Cable circular saws. This washer is a special hardware that helps to provide a tight fit for the saw blade. It is an identical replacement for a damaged or a missing hardware that was installed on a new unit. Check the diagrams for your model for the ex...Read moreact location and the correct installation of this part. One durable metal washer is included. You will need a wrench to remove and resecure the blade bolt to replace this washer.

It is a genuine OEM supplied replacement screw which is specially designed for use with power tools. This is one of the screws for the unit, please refer to the appropriate diagrams of your model for the correct location and use of this hardware. Please note it is made of high-quality metal and is sold individually.

This is a genuine manufacturer-sourced replacement screw, it is specially designed for use with Porter Cable circular saws. It is a standard hardware which has multiple applications depending on the model of your equipment, please refer to the appropriate diagrams for the correct location and use of this part. This screw is made of high-quality metal and it is sold individually.

This Ball Bearing has metal shielding on both sides. This is a genuine Porter Cable replacement part that is sold individually. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This ...Read morereduces wear on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This is a genuine Porter Cable product sourced from the original manufacturer, not an aftermarket imitation. The tube of grease is 5.5 ounces, and is used to lubricate various kinds of equipment, and power tools. This tube of grease is sold individually, please see model diagram for compatibility, and usage.

Genuine Porter Cable replacement part, this item is sold individually. This screw is used in various parts of the tools shown below. It can found in each of the tools securing different internal parts of these tools. It is a Torx T-25 screw.

This is a genuine Porter Cable replacement part, it is sold individually. This Brush Cap is used on the model numbers shown below. To remove this part ,simply use a flat head screw driver. Don't use top much pressure on it, they do have a tendency to break.