J-305 (Type 1) Porter Cable Sander Polisher - Overview

Included in part number 450503-01

This replacement carbon brush is an authentic component which is supplied directly from the original equipment manufacturer for use with Porter Cable sanders and polishers. Carbon brushes play an important role by conducting electric current while maintaining physical contact with an armature. Over time due to normal use the brushes will ...Read morewear away eventually requiring replacement to maintain peak performance. It is a high-quality carbon brush with an attached lead wire and a spring, please note this it is sold individually.

The washer goes next to the brush holder. This is made out of metal and is sold individually. It is a genuine OEM sourced part which is specially designed for use with Porter Cable and DeWALT band saws, planers, polishers, routers, and sanders. During the installation process, a screwdriver might be needed to replace this item. Over time this part may break and will need to be replaced.

This cord is a genuine Porter Cable replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 3 Prongs • 3 Wires • 16 Gauge • 10 Feet Long

It is a genuine OEM sourced replacement spanner wrench which is specially designed for use with Porter Cable plate joiners and sanders. This spanner wrench allows a user to secure or remove the grinding disk, angular profile of this item makes tightening and loosening the arbor nut extremely easy. It is made of high-quality metal and it is sold individually.

This Ball Bearing has metal shielding on both sides. This is a genuine Porter Cable replacement part that is sold individually. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This ...Read morereduces wear on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

It is a genuine item which is made for use with Porter Cable power tool. This part is supplied directly from the original equipment manufacturer. It is a special component which helps to connect two lead wires. The part is utilized to connect the on/off switch to the tool. It is a simple plastic item which is sold individually. Replacing ...Read moreit will only require a screwdriver, take apart the housing, remove the old part and secure the wires using the new connector.

This is a needle bearing that is open on both sides. This genuine Porter Cable replacement part is sold individually. • Ball bearings minimize friction between rotating parts in your tool. The balls or rollers bear the load and spin, distributing the weight evenly, while the minimal contact area of the balls reduces friction. This reduc...Read morees wear on the tool, allowing it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This a high quality hardware designed for use on Black and Decker, Dewalt and Porter Cable power tools. It is a genuine item that is sourced directly from original equipment manufacturer. This screw has multiple applications depending on the equipment. Always make sure to check appropriate diagrams for correct location and use of this hardware. One torx screw is included per order.