IPA1882054 Industrial Air Compressor - Overview

This is a genuine OEM sourced replacement valve kit designed for use with Powermate equipment. The purpose of the valve plate is to allow air into the cylinder. Once the piston starts traveling up the reeds on the valve plate open and the air is sent into the tank. Over time valves and gaskets will become worn and would need to be replace...Read mored to keep your equipment running well. To complete this repair you would need a wrench set and a screwdriver to take off the housing and the cylinder head. Keep in mind this high-quality valve plate assembly is made of durable metal and is sold as an individual component.

This is an authentic replacement part manufactured for use with Powermate electric air compressors. The head gasket is used to form a seal at the connection between the valve plate and the cylinder head. This head gasket is available as an individual replacement part, please see model diagram for associative parts.

It is a genuine item that is supplied by the original equipment manufacturer for use with Powermate air compressors. This is a high-quality replacement for a missing or damaged gasket which provides an air-tight seal for the cylinder, please refer to the appropriate diagrams of your model for the correct location and application of this hardware. It is made of high-quality composite material and is sold individually.

This is a genuine replacement part sourced from the original manufacturer for use with electric two stage air compressors made by Powermate. When the air compressor reaches the maximum air pressure, this valve bleeder releases the air. It is recommended to review your models diagram to verify the parts compatibility. This part is sold individually and made of durable material.

This authentic item is supplied directly from the original equipment manufacturer for use with air compressors made by Powermate and Husky. The flywheel attaches to the oil seal and the carrier. When replacing this part a socket set and a wrench set might be required during the installation process. It is made out of metal and will need to be replaced if it breaks. This item is sold individually.

This is a genuine OEM sourced part which is specially designed for use with Powermate and Husky air compressors. The breather acts as a valve for the fuel tank, it allows for the air to enter the fuel tank but it won\\\'t allow fuel or fuel emissions to leave the tank. It provides an identical replacement for a missing or a faulty compone...Read morent that was installed on a new unit. Keep in mind this high-quality part is made of durable plastic and is sold individually.

The pressure switch is a genuine Powermate part that is used to replace the original switch that was part of the air compressor when new. The switch assembly is used to turn the pump on or off based on the set level of the air pressure. This item is priced as a single part.

This is an original Powermate replacement part. The hubcap is commonly found on air compressors. This part is made of metal, and is used to secure the wheel to the axle. Please note that these hubcaps are not reusable, and you will need to replace them every time you remove the wheel. It may require some extra effort to get the old pa...Read morert off, using pliers or a screwdriver. Once it is removed, the new part can be easily fitted into place. This item is sold individually.

The petcock attaches to the bushing and the o-ring and is made of metal. This part is an OEM from Powermate for use in air compressors. Keep in mind this high-quality part is sold individually. An adjustable wrench might be needed during the installation process. This item may become broken or stripped and will need to be replaced.