IP1682066MN Industrial Air Compressor - Overview

This part is sold individually. The flywheel attaches to the carrier and is made of metal. A screwdriver may be required to replace this part. Over time this item may break and will need to be replaced. This part is an OEM sourced directly from the manufacturer for use in Powermate compressors.

This is an original Powermate replacement part. The hubcap is commonly found on air compressors. This part is made of metal, and is used to secure the wheel to the axle. Please note that these hubcaps are not reusable, and you will need to replace them every time you remove the wheel. It may require some extra effort to get the old pa...Read morert off, using pliers or a screwdriver. Once it is removed, the new part can be easily fitted into place. This item is sold individually.

The petcock attaches to the bushing and the o-ring and is made of metal. This part is an OEM from Powermate for use in air compressors. Keep in mind this high-quality part is sold individually. An adjustable wrench might be needed during the installation process. This item may become broken or stripped and will need to be replaced.

This authentic item is supplied directly from the original equipment manufacturer for use with Powermate air compressors. It is an identical replacement for a missing or a damaged nut that was installed on a new unit. Check the appropriate diagrams for your model for the exact location and the correct application of this component. Keep i...Read moren mind this high-quality nut is made of durable metal and is sold individually. A wrench will be needed to secure and remove it.

This is an authentic Powermate replacement part that is sourced from the original manufacturer for use with air compressors. The special three wire cord is used to supply the compressor\\\'s motor with electricity. This cord is available as an individual replacement part, please model diagram for associative parts.

This part is an OEM from Craftsman. The valve allows pressurized air flow into the tank and prevents air flow from flowing back into the pump of the air compressor. Wire cutters and a socket wrench will be needed to replace the valve. The wire cutters are used to remove the hose clamp and the socket wrench are used to loosen and tighten the valve. This part is made of metal and is sold individually.