HX500100 (2004) Campbell Hausfeld Compressor - Overview

This ASME safety valve is constructed of high-qualty metal, and is made for use with many air compressor models. Fastened to the manifold, the safety valve diminishes air pressure when the pump is not shut off at the proper setting. This important component is sold individually. A screwdriver, adjustable wrench and a pair of pliers are of...Read moreten necessary for the removal and replacement. Please refer to the specific manual for additional repair information.

This item is an original part from Campbell Hausfeld for use in compressors. The pressure switch unloader valve connects to the pressure switch. A wrench set and a screwdriver may be necessary during the installation of this part. The valve is made out of metal and will need to be replaced if it breaks since it can cause air leaks. This item is priced individually but also includes three nuts.

This is a genuine Campbell Hausfeld replacement drain valve, sold individually. When using an air compressor, moisture naturally condenses inside the tank. If this water is left sitting for too long, it can lead to internal rust and damage. The drain valve allows you to release this built-up moisture easily. It's especially important to d...Read morerain your tank after each use—particularly if you tend to leave air in the tank for extended periods. Regular draining helps extend the life of your compressor and maintain its performance. Be sure to open the valve regularly to prevent water buildup and potential tank corrosion.

This genuine OEM replacement nipple is designed for use in air compressors, serving as a critical connector between the pressure switch, the tank, and the regulator. A damaged or corroded nipple can lead to air leaks and inconsistent pressure, affecting overall performance. To check for leaks, apply soapy water to the fittings around the ...Read morepressure switch and watch for bubbles. If replacement is necessary, the process typically involves disassembling the pressure switch. Begin by draining the tank using the valve at the bottom, then remove the coupler from the regulator and unthread the nipple. Access the wire connections by removing the pressure switch shroud, and carefully note the position of each wire before disconnecting them—starting with the motor wire, followed by the cord wires and ground wires. Remove the strain relief, pressure gauge, and the airline connecting the check valve to the switch. Finally, unthread the pressure switch from the tank nipple and remove the nipple itself. When reassembling, it is recommended to use thread tape to ensure a proper seal. This replacement part is sold individually.

This is an authentic manufacturer-sourced component which is specially made for use with Campbell Hausfeld air compressors. The unloader tube is connected to the pressure switch to allow excess pressure to drain out. Unfortunately, over time it will wear out and it may begin to fail eventually requiring a replacement. Keep in mind this hi...Read moregh-quality item is made of durable material and is sold individually. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this part.