HU351000AV Campbell Hausfeld Compressor - Overview

This ASME safety valve is constructed of high-qualty metal, and is made for use with many air compressor models. Fastened to the manifold, the safety valve diminishes air pressure when the pump is not shut off at the proper setting. This important component is sold individually. A screwdriver, adjustable wrench and a pair of pliers are of...Read moreten necessary for the removal and replacement. Please refer to the specific manual for additional repair information.

This item is an original part from Campbell Hausfeld for use in compressors. The pressure switch unloader valve connects to the pressure switch. A wrench set and a screwdriver may be necessary during the installation of this part. The valve is made out of metal and will need to be replaced if it breaks since it can cause air leaks. This item is priced individually but also includes three nuts.

This is a genuine Campbell Hausfeld replacement part which is designed for use with air compressors. It is utilized to regulate the air pressure in the tank. Over time components may wear out and begin to fail eventually requiring replacements. Refer to the owner's manual and the appropriate diagrams for your model to ensure the proper re...Read morepair procedure. Note, this high-quality kit includes the metal body regulator, the knob, and the hardware to secure the regulator. A screwdriver and a wrench set will be needed to replace these components.

This is a genuine Campbell Hausfeld replacement part. The pressure switch knob is designed by the manufacturer for use in air compressors. This part is made of high-quality plastic, and is placed in the front shroud panel in conjunction with the pressure switch assembly to allow the user to control the pressure settings. This part is sold individually.

This is an OEM part sourced directly from the manufacturer. The drain knob is commonly found in air compressors from Campbell Hausfeld. This part is a high-quality plastic knob with a threaded metal shaft and rubber stopper connection. It is used with the drain valve to allow air and water condensation to drain out of the compressor ta...Read morenk at the end of use. No tools are required when replacing this item. Simply remove the old part and screw the new one into place. This item is sold individually.

It is a genuine replacement component which is supplied directly from the original equipment manufacturer for use with Campbell Hausfeld air compressors. These are the special gaskets that are utilized to provide an air-tight seal for the cylinder head, make sure to refer to the appropriate diagrams of your model for the correct location ...Read moreand application of this hardware. It is a high-quality kit which includes two high-quality composite material gaskets.