Models
>
HT230
HT230 Shindaiwa Hedge Trimmer - Overview
Sections of the HT230
[Viewing 13 of 13]Keep searches simple, eg. "belt" or "pump".
Primer Pump
PartSelect #: PS8858167
Manufacturer #: 12318140630
The Primer Pump, aka the Pump Bulb, is a clear, individually sold, plastic part, sourced from the original equipment manufacturer. It has an Outer Diameter of 0.616 Inches, 15.66mm and is 0.558 Inches...
$4.99
In Stock
Fuel Filter
PartSelect #: PS11836543
Manufacturer #: A369000440
This OEM Fuel Filter is a white and silver, steel part, sold individually. It requires a pair of pliers to install and is ranked as Easy to repair by our customers. This part attaches inside of the fu...
$6.82
In Stock
Clip 6
PartSelect #: PS9238696
Manufacturer #: V490000500
This OEM Clip is a silver, steel part, which is sold individually. The part secures the fuel line to the fuel filter and is rated as Easy to install.
You will know you need a new one if there is a l...
$4.99
In Stock
Primer Cover
PartSelect #: PS8857330
Manufacturer #: 12314205560
This genuine Primer Cover, or Primer Pump Cover, is a silver, individually sold, steel part with dimensions of around 1x1 inch.
This part is installed using a screwdriver, and is rated as Easy to ins...
$4.99
In Stock
Questions And Answers for HT230
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Sort by:
- < Prev
- 1
- Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Steven
July 22, 2023
Is there a video to replace the cutter
For model number HT230
Hello Steven, thank you for your inquiry. We have found some relevant instructions for you to replace the blade. They may not be of the exact same model, but they will help you with the process. You may follow the following steps: set the trimmer on its side with the muffler facing down. Use two ten millimeter sockets to remove the locking nuts securing the trimmer blades. Remove the blade guard and washers along with the tip guard. Now, set the trimmer upside down and use a torx bit to unthread the screws securing the gear case cover. With the screws unthreaded, lift off the cover and remove all the blade's mounting bolts and washers. Use pliers to lift out the felt seal. Remove the outer spur gear and carefully lift off the lower blade. Lift off the spacer plate and then remove the upper blade. We hope this sorts out your problem!
Was this helpful?
Thank you for voting!
- < Prev
- 1
- Next >