HS7810 (2000) Campbell Hausfeld Compressor - Overview

This part is an OEM from Campbell Hausfeld. The drain cock-npt 3/8 is compatible with many air compressors, and is sold individually. The metal component allows the operator to drain the condensation out from the compressor tank. Located at the base of the tank, a wrench set is required for the replacement. Please be sure to refer the manual for further safety and repair instructions.

Genuine Campbell Hausfeld replacement part, this item is sold individually. The ST033001AV Compression Nut is used to attach the copper tubing to certain components of the compressors listed below. Along with the Compression Nut you will need to use a compression sleeve ( or Ferrule) to seal the tube from leaking air. The Compression Nut will go on the tubing first then the Ferrule will slide into the nut.

Sourced directly from the manufacturer, this plug is an exact replacement part for a variety of air compressors. This part is sold individually, not as part of a kit or assembly. It is gold, made of metal, and will be found on the pressure switch. This part will leak when it has become defective and will need to be replaced if it is dam...Read moreaged or worn. When you install the part, apply Teflon tape to the threads before tightening it in place. You will need a wrench to complete this repair. Customers rate this repair as Easy.

This is an authentic OEM part. The 1/2 compression sleeve is compatible with many air compressor machines. With the compression nut, this item helps to secure the exhaust tube to the front shroud. An adjustable wrench is necessary for the replacement. The compression sleeve is sold individually.

This is an authentic Campbell Hausfeld replacement part designed to filter out dust and other contaminants on an air compressor. It is sourced directly from original equipment manufacturer and it is sold individually. This filter element consists of a pleated paper in a plastic frame. Replace this air filter element does not require any ...Read moretools. • Remove the filter cover • Remove the old filter element • Secure the new filter in place • Attach the filter cover

This is an OEM part sourced directly from the manufacturer. The pressure switch is commonly found in Campbell Hausfeld air compressors. This part is a complete assembly made of metal and plastic, and is used to turn the machine on and off automatically to maintain a set level of pressure in the tank. You may require a wrench when repla...Read morecing this item. The pressure switch is available as an individual replacement part.

The check valve attaches to the ferrule and the compression nut. It is a genuine item that is supplied by the original equipment manufacturer for use with Campbell Hausfeld compressors. This part is made of metal and is available individually. During replacement, it may require a wrench to help install this part correctly. It will require replacing if it becomes broken.