HS516000AJ Campbell Hausfeld Compressor - Overview

This is an authentic replacement part manufactured for use with Campbell Hausfeld pressure washers. The pressure switch is used to turn the pump on or off depending on the amount of air pressure within the tank. A faulty switch will likely prevent the pump from turning on when the pressure in the tank is low. This switch is available as an individual replacement part, please see model diagram for associative parts.

Genuine Campbell Hausfeld replacement part, this item is sold individually. The ST033001AV Compression Nut is used to attach the copper tubing to certain components of the compressors listed below. Along with the Compression Nut you will need to use a compression sleeve ( or Ferrule) to seal the tube from leaking air. The Compression Nut will go on the tubing first then the Ferrule will slide into the nut.

This is an authentic Campbell Hausfeld replacement part that has been sourced from the original manufacturer to be used with air compressors. The belt attaches to the motor pulley and the pumps flywheel. This item allows the rotation of the motors driveshaft to rotate the pumps crankshaft. This item is sold as an individual replacement part.

This is an authentic OEM part. The 1/2 compression sleeve is compatible with many air compressor machines. With the compression nut, this item helps to secure the exhaust tube to the front shroud. An adjustable wrench is necessary for the replacement. The compression sleeve is sold individually.

This is a genuine Campbell Hausfeld replacement drain valve, sold individually. When using an air compressor, moisture naturally condenses inside the tank. If this water is left sitting for too long, it can lead to internal rust and damage. The drain valve allows you to release this built-up moisture easily. It's especially important to d...Read morerain your tank after each use—particularly if you tend to leave air in the tank for extended periods. Regular draining helps extend the life of your compressor and maintain its performance. Be sure to open the valve regularly to prevent water buildup and potential tank corrosion.

1/4

It is an authentic replacement item that is specially supplied by original equipment manufacturer for use with Campbell Hausfeld air compressors. This is the push-in fitting for the check valve which is sold separately. It is a quick-connect style fitting that is designed to accommodate for 1/4

The check valve attaches to the ferrule and the compression nut. It is a genuine item that is supplied by the original equipment manufacturer for use with Campbell Hausfeld compressors. This part is made of metal and is available individually. During replacement, it may require a wrench to help install this part correctly. It will require replacing if it becomes broken.

This is an authentic replacement part manufactured for use with Campbell Hausfeld air compressors. The pressure gauge is used to measure the amount of pressurized air inside the tank. The guage has a plastic housing and clear cover. The guage is threaded and may require a wrench to install, please note the guage is sold individually.