This is the replacement charcoal filter for your microwave. It is silver and black in color and measures approximately 10 inches by 2 ½ inches. The charcoal filter removes cooking odors from the air that circulates through the microwave vent. You will likely need to replace the charcoal filter if you notice any damage to it, or if it has...Read more been in your microwave for a long time. This part is sold individually and is an authentic OEM part sourced directly from the manufacturer.
This 13.5-inch glass turntable tray is designed to fit a variety of microwave models, particularly those from GE and Hotpoint. Constructed from food-safe, heat-resistant tempered glass, it ensures consistent and even heating by rotating food during operation. The tray features a smooth surface and a sturdy build for long-term durability. ...Read moreOn the underside, it includes three distinct grooves that align precisely with the microwave’s central bushing coupler, allowing secure placement and smooth rotation. The outer diameter of the tray is approximately 13.5 inches, while the recessed track underneath measures about 10.25 inches across, ensuring compatibility with standard
This turntable motor is for microwaves.
The turntable motor rotates the glass tray inside the microwave oven.
Because high-voltage capacitors in a microwave can retain a lethal electrical charge even when the microwave is unplugged, a service technician should install this part.
1. Unplug unit 2. Open door, remove two screws above the top trim piece, slide and remove trim. 3. Remove screw behind control board and top left corner, then release from position. 3b. Unplug all wire terminations and set control panel aside. 4. Remove two screws securing latch board, lift and rotate board
... Read moreout of position, remove three micro switches, xfer monitor switch actuator from lower pin in old board and insert in new. Install new door switches and reverse procedure to complete repair.
Note 1. Take care to located new latch board so holding tabs line up, pass through frame, and openings for door tangs line up with openings in frame before securing with screws.
Note 2. A long magnetic screwdriver is helpful.
Read less
Was this helpful?
Thank you for voting!
Had to replace charcoal filter
15 of 25 peoplefound this instruction helpful.
Jared from SIERRA VISTA, AZ
Easy
15 - 30 mins
Open the front cover by pushing it at the top (where it says “Push”), lifting up and pushing back on top edge of the old filter. Pull it out. Installing the new one is basically just the reverse of those steps! That simple.
Old filter did seem to be a little thicker (filter material), but the new one was the exact same dimen
... Read moresions, so it went in properly. Wish the filter material was white, so you knew just how dirty it was actually getting. But... :-D
Read less
Was this helpful?
Thank you for voting!
Mirowave door latch
6 of 11 peoplefound this instruction helpful.
Fernando from WEST CHESTER, PA
Really Easy
Less than 15 mins
While installing a filter in my brand new never been used microwave range hood combo I snapped off the top door latch with my elbow. After a few expletives I search You Tube and found it was a simple fix. I ordered a replacement latch from this site. It arrived in three days and it took 5 minutes to fix.