HL432600 Campbell Hausfeld Compressor - Overview

This ASME safety valve is constructed of high-qualty metal, and is made for use with many air compressor models. Fastened to the manifold, the safety valve diminishes air pressure when the pump is not shut off at the proper setting. This important component is sold individually. A screwdriver, adjustable wrench and a pair of pliers are of...Read moreten necessary for the removal and replacement. Please refer to the specific manual for additional repair information.

Sourced directly from the manufacturer, this plug is an exact replacement part for a variety of air compressors. This part is sold individually, not as part of a kit or assembly. It is gold, made of metal, and will be found on the pressure switch. This part will leak when it has become defective and will need to be replaced if it is dam...Read moreaged or worn. When you install the part, apply Teflon tape to the threads before tightening it in place. You will need a wrench to complete this repair. Customers rate this repair as Easy.

This item is an original part from Campbell Hausfeld for use in compressors. The pressure switch unloader valve connects to the pressure switch. A wrench set and a screwdriver may be necessary during the installation of this part. The valve is made out of metal and will need to be replaced if it breaks since it can cause air leaks. This item is priced individually but also includes three nuts.

This is a genuine Campbell Hausfeld replacement drain valve, sold individually. When using an air compressor, moisture naturally condenses inside the tank. If this water is left sitting for too long, it can lead to internal rust and damage. The drain valve allows you to release this built-up moisture easily. It's especially important to d...Read morerain your tank after each use—particularly if you tend to leave air in the tank for extended periods. Regular draining helps extend the life of your compressor and maintain its performance. Be sure to open the valve regularly to prevent water buildup and potential tank corrosion.

This genuine OEM replacement nipple is designed for use in air compressors, serving as a critical connector between the pressure switch, the tank, and the regulator. A damaged or corroded nipple can lead to air leaks and inconsistent pressure, affecting overall performance. To check for leaks, apply soapy water to the fittings around the ...Read morepressure switch and watch for bubbles. If replacement is necessary, the process typically involves disassembling the pressure switch. Begin by draining the tank using the valve at the bottom, then remove the coupler from the regulator and unthread the nipple. Access the wire connections by removing the pressure switch shroud, and carefully note the position of each wire before disconnecting them—starting with the motor wire, followed by the cord wires and ground wires. Remove the strain relief, pressure gauge, and the airline connecting the check valve to the switch. Finally, unthread the pressure switch from the tank nipple and remove the nipple itself. When reassembling, it is recommended to use thread tape to ensure a proper seal. This replacement part is sold individually.

This is a genuine Campbell Hausfeld replacement part. The gauge is designed by the manufacturer for use in air compressors. This is a complete assembly made primarily of high-quality plastic and metal, and it is placed in the pressure switch to monitor the pressure within the tank. This part is sold individually.

An authentic manufacturer-sourced replacement part that is specially designed for use with Campbell Hausfeld air compressors. These special components are secured to the main frame helping to reduce vibrations from a working engine, over time the material may begin to deteriorate and crack eventually requiring replacement. It is a high-qu...Read moreality kit which includes two durable rubber feet and the hardware to secure them.

This is an authentic Campbell Hausfeld replacement part, sourced from the original manufacturer for use with oil-lubricated air compressors. The plastic shroud is used to cover and protect the motor's fan and pump assembly. This special shroud is available as an individual replacement part, please see illustrated diagram for related items.