HGC14S Waring Blender - Overview

This is a genuine manufacturer sourced replacement part used on Waring blenders. It helps to distribute the pressure evenly and provides a tight seal for the bearing holder. It is installed along with other seals and washers underneath the cutter assembly, to prevent leaks from coming out of the bottom of the container. Over time these se...Read moreals and washers will become brittle and compressed, then will have to be replaced. For proper application please refer to diagrams of your unit. This part is made out of rubber material and it is sold individually. To complete this repair you will need a wrench.

This is a genuine manufacturer approved replacement part designed for use on Waring blenders. This item fills the center hole in the outer lid. It is made out of clear plastic and it is sold individually.

Genuine Waring replacement part, this item is sold individually. This part acts as a seal for the blenders shown below. It is installed along with other seals and washers underneath the cutter assembly, to prevent leaks from coming out of the bottom of the container. Over time these seals and washers will become brittle and compressed, then will have to be replaced.

This is an authentic replacement part sourced from the original manufacturer for use with blenders made by Waring. The user will need to replace this part if it is missing. Unfortunately, over time it may wear out. This washer is made of metal and sold individually.