HD775-3033 Kohler Engine - Overview

This is an authentic Kohler replacement part that is manufactured for use with small engines. The stud is used to support the housing for the starter recoil assembly. These studs are sold as individual replacement parts.

The diaphragm attaches to the screw shoulder and is made of plastic and metal. This part is available as an individual replacement. This genuine item is supplied by the original equipment manufacturer for use with Kohler engines and Husqvarna lawn mowers. During replacement, it may require a set of pliers, a socket set, a wrench set, and ...Read morea torx driver to help install this part correctly. It will require replacing if it breaks.

This replacement part is a genuine OEM sourced recoil starter assembly. It is specially manufactured for Kohler engines installed on lawn and garden equipment. This assembly allows user to pull-start the engine. It consists of a plastic shroud, starter pulley, starter spring, grip and the pull rope. Please note the screws to attach this s...Read moretarter assembly are sold separately. You will need a screwdriver to complete this repair. • Disconnect the spark plug • Remove the screws that secure the starter • Remove the old starter assembly • Secure the new assembly with the screws

This genuine OEM part is designed for use with Kohler engines commonly installed on a variety of lawn and garden equipment. The purpose of this part is to mix air and gas before the fuel mix goes to the engine. If the engine won't start and the tank is full of fresh fuel, test the carburetor by removing the air filter and pouring about a ...Read moreteaspoon of fuel into the carburetor. Pull the starter rope. If the engine starts and then quickly dies, the carburetor is likely the problem. To complete this repair you would need a screwdriver and a wrench set. Note, the kit includes one durable metal body carburetor and two gaskets to ensure a tight fit.

This is an authentic part from Kohler for use in engines. The oil seal fits between the flat washer and the clip governor shaft. If this item becomes broken it will need to be replaced and may require a set of pliers during the installation. This is available as an individual replacement part and is made of plastic and rubber.

This is an authentic manufacturer-sourced component that is specially manufactured for use with Kohler engines commonly installed on lawn and garden equipment. The stud is utilized to support the housing for the starter recoil assembly, please make sure to refer to the appropriate diagrams of your model for the correct location and applic...Read moreation of this part. Keep in mind this high-quality hardware is made of durable metal and is sold individually.