GX160T1VWW2 Honda Engine - Overview

This is an authentic Honda replacement part, sourced from the original manufacturer for use with small engines. The special hex head bolt is commonly used to secure the ignition module assembly. This flanged bolt is available as an individual replacement part, please see illustrated part list for associative parts.

This is an authentic manufacturer sourced replacement part designed for use with Honda engines. This carburetor gasket provides an air tight seal between the carburetor and the insulator. Over time gaskets tend to deteriorate and would need to be replaced. It is made out of compound material and it is sold individually. You would need a screwdriver to replace this item.

It is an authentic item that is supplied directly from the original equipment manufacturer for use with Honda engines commonly installed on lawn and garden equipment. This is an identical replacement for a missing or damaged seal for the valve stem, please refer to the appropriate diagram of your model for the correct location and applica...Read moretion of this hardware. It is a high-quality component is made of durable rubber and is sold individually.

This item has been sourced from the original manufacturer, and it is intended to be used with small engines from Honda. The metal spring links with the starter pulley and is used to recoil the roper back around the pulley after the rope is pulled. This item is available as an individual replacement part.

This is an original part from Honda that is used in a small engine. The key sits in the keyway and keeps the flywheel from free spinning when turned. This part is half mooned shaped and is made of metal. This part is sold as an individual replacement part.

The flange bolt is used to secure parts together in a variety of lawn and garden outdoor equipment. It is sourced directly from the manufacturer and has a diameter of 6mm and a length of 12mm. The bolt is made of metal and has a ring-shaped rim on one end known as a flange. This flange helps to secure the bolt in place and prevents it fro...Read morem falling off during use. Inspect all the bolts on your equipment as you may need more than one. If you note that any of them are deformed, corroded or the threads are worn down, you will need to replace them as each bolt is sold individually. Remove the damaged bolt and thread the new one on with your hands before tightening with a wrench.

This OEM-manufactured flange bolt provides a secure connection between two parts of your equipment. What is different about a flange bolt is that it has a wide, flat flange at the end. This helps to distribute the load being applied to it and prevents the bolt from becoming loose. Flange bolts are commonly found in lawn equipment, but the...Read moreir location varies by the make and model of the machine. When damaged, the part that the flange bolt was holding may loosen and fall off. You also may observe that it the flange bolt is cracked or corroded. It is important for you to replace broken flange bolts immediately as loose or vibrating parts can detach from your equipment while it is operating. You need a socket wrench to remove a flange bolt, as well as rust dissolver or penetrating oil if it is stuck. This replacement part is sold individually so make sure that you consult your user guide to identify where your flange bolts are and how many your equipment needs.

This is an authentic Honda replacement part sourced from the original manufacturer for use with small engines. The gasket is used to seal the crankcase cover, and it is recommended to replace gaskets when servicing a small engine to ensure proper seals when reassembling the engine. This case cover gasket is available as an individual replacement part.

This item is an authentic Honda replacement part that has been sourced from the original manufacturer to be used with small engines. The gasket is used to seal the connection between the carburetor insulator and the cylinder's intake. This item is available as an individual replacement part.

This part is an OEM from the Honda manufacturer. The valve rocker arm is made for use with many small engines. This metal component is designed to open and close the valve. Over time it may wear out or get damaged eventually requiring a replacement. The valve rocker arm is sold individually. Please be sure to refer to the specific manual ...Read morefor repair instructions. When replacing the valve rocker arm, a wrench set is necessary.