GX160K1 (Type NJC1) Honda Engine - Overview

This is an authentic manufacturer sourced replacement part designed for use with Honda engines. This carburetor gasket provides an air tight seal between the carburetor and the insulator. Over time gaskets tend to deteriorate and would need to be replaced. It is made out of compound material and it is sold individually. You would need a screwdriver to replace this item.

It is an authentic item that is supplied directly from the original equipment manufacturer for use with Honda engines commonly installed on lawn and garden equipment. This is an identical replacement for a missing or damaged seal for the valve stem, please refer to the appropriate diagram of your model for the correct location and applica...Read moretion of this hardware. It is a high-quality component is made of durable rubber and is sold individually.

This is an authentic Honda replacement part sourced from the original manufacturer for use with small engines. The gasket is used to seal the crankcase cover, and it is recommended to replace gaskets when servicing a small engine to ensure proper seals when reassembling the engine. This case cover gasket is available as an individual replacement part.

This is a genuine Honda replacement part. The pilot screw is designed by the manufacturer for use in small engines. This part includes a metal screw and a spring, and is used to adjust the flow of fuel and air in the carburetor. You will require a screwdriver when replacing these parts.

This item is an authentic Honda replacement part that has been sourced from the original manufacturer to be used with small engines. The gasket is used to seal the connection between the carburetor insulator and the cylinder's intake. This item is available as an individual replacement part.

This is an authentic replacement part sourced directly from the manufacturer. The stop switch wire is commonly found in Honda small engines. This part is made of metal wire with a flexible plastic casing, and is used to send signals from the engine stop switch to the engine. You may require a wrench and pliers when replacing this item. This product is available as an individual replacement part.

This compression spring is sourced directly from the original equipment manufacturer for use with Honda engines commonly installed on a variety of lawn and garden equipment. It is an important component that allows the throttle to retract. Over time it may wear out and lose tension eventually requiring a replacement. To ensure the correct...Read more installation of this hardware, check the diagrams of your specific model. Keep in mind this high-quality spring is made of durable metal and is sold as an individual component. You may need a screwdriver and pliers to perform this repair.

This is an authentic manufacturer-sourced replacement part which is specially designed for use with Honda engines commonly installed on lawn and garden equipment. The purpose of a this component is to provide a tight seal between components, make sure to refer to the appropriate diagrams of your model for the correct location and applicat...Read moreion of this hardware. Keep in mind this high-quality item is made of durable rubber material and is sold individually.

This is a genuine OEM supplied replacement part that is specially designed for Honda engines that are commonly installed on a variety of lawn and garden equipment. The ignition coil which is also known as an armature-magneto provides current for the ignition system by producing pulses of high voltage electricity for the spark plugs. While...Read more there are various reasons for ignition module failure, the primary symptoms usually manifest in the form of extreme difficulty starting your equipment, and eventually, a no-start condition. It is made of high-quality metal with rubber insulated cord and is sold as an individual component. A wrench set will be needed to replace this coil assembly.

This is an OEM Honda part directly sourced from the manufacturer for use in small engines. The governor rod hooks to the governor arm. You may need a wrench and a set of pliers when replacing this part. This item may become broken or bent and will need to be replaced. It is made of metal and is available as an individual replacement part.