GX120U1K Honda Lawn Mower - Overview

This is an authentic Honda replacement part, sourced from the original manufacturer for use with small engines. The special hex head bolt is commonly used to secure the ignition module assembly. This flanged bolt is available as an individual replacement part, please see illustrated part list for associative parts.

This is an authentic manufacturer sourced replacement part designed for use with Honda engines. This carburetor gasket provides an air tight seal between the carburetor and the insulator. Over time gaskets tend to deteriorate and would need to be replaced. It is made out of compound material and it is sold individually. You would need a screwdriver to replace this item.

It is an authentic item that is supplied directly from the original equipment manufacturer for use with Honda engines commonly installed on lawn and garden equipment. This is an identical replacement for a missing or damaged seal for the valve stem, please refer to the appropriate diagram of your model for the correct location and applica...Read moretion of this hardware. It is a high-quality component is made of durable rubber and is sold individually.

This item has been sourced from the original manufacturer, and it is intended to be used with small engines from Honda. The metal spring links with the starter pulley and is used to recoil the roper back around the pulley after the rope is pulled. This item is available as an individual replacement part.

This is an OEM Sourced replacement part used on Honda Engines. This Filter is made out of Paper, Foam and Metal. This item is Sold Individually. Its purpose is to filter out dust and debris from contaminating the engine. To replace this you would need a Wrench to remove the Air Cleaner Cover.

This part is a genuine OEM item that has been sourced to be used with Honda small engines. This spacer is used as a link between the carburetor and the air cleaner elbow. The carburetor spacer is priced as an individual part, please note associative parts are available separately.

This is an original part from Honda that is used in a small engine. The key sits in the keyway and keeps the flywheel from free spinning when turned. This part is half mooned shaped and is made of metal. This part is sold as an individual replacement part.

The fuel hose attaches to the tube clip and the fuel filter. This part is available individually. It is a genuine OEM sourced part which is specifically designed for use with Honda and Toro engines. You may need a set of pliers when replacing this part. This item is made out of rubber and will need to be replaced if it breaks.

This is an authentic manufacturer-sourced component which is designed for use with Honda engines that are commonly installed on a variety of lawn and garden equipment. It is an identical replacement for a damaged or a missing clutch cam that was installed on a new unit. Over time the material will wear out and it may begin to crack eventu...Read moreally requiring a replacement. It is made of high-quality rubber and is sold individually.

The noise suppressor cap assembly, also known as the spark plug cap/boot is responsible for connecting the spark plug to the ignition coil, and helping to reduce the amount of noise created when running outdoor power equipment. This OEM replacement part includes a rubber cap with a metal contact inside. It is found at the end of the spark...Read more plug wire and has a threaded center shaft which allows you to easily screw it into position. Over time the metal contact may corrode, or the cap may dry out and crack or break. If your equipment is misfiring, running poorly, or has interference with other electronic equipment, the cap assembly likely needs to be replaced. To remove the old cap assembly, use your fingers or a set of pliers to carefully pull it off the end of the wire. Place the new cap assembly onto the end of the wire and fasten it securely. Please note this part is sold individually.