GR3300 Campbell Hausfeld Compressor - Overview

This part is an OEM from Campbell Hausfeld. The drain cock-npt 3/8 is compatible with many air compressors, and is sold individually. The metal component allows the operator to drain the condensation out from the compressor tank. Located at the base of the tank, a wrench set is required for the replacement. Please be sure to refer the manual for further safety and repair instructions.

This is a genuine Campbell Hausfeld replacement drain valve, sold individually. When using an air compressor, moisture naturally condenses inside the tank. If this water is left sitting for too long, it can lead to internal rust and damage. The drain valve allows you to release this built-up moisture easily. It's especially important to d...Read morerain your tank after each use—particularly if you tend to leave air in the tank for extended periods. Regular draining helps extend the life of your compressor and maintain its performance. Be sure to open the valve regularly to prevent water buildup and potential tank corrosion.

This is an authentic Campbell Hausfeld replacement part designed to filter out dust and other contaminants on an air compressor. It is sourced directly from original equipment manufacturer and it is sold individually. This filter element consists of a pleated paper in a plastic frame. Replace this air filter element does not require any ...Read moretools. • Remove the filter cover • Remove the old filter element • Secure the new filter in place • Attach the filter cover

This is a genuine Campbell Hausfeld replacement part that has been sourced from the original manufacturer to be used with air compressors. The oil level gauge attaches to the crankcase housing and is used to provide an indication of the amount of oil inside the case. This part is priced as a single item.

It is an authentic replacement item that is specially supplied by original equipment manufacturer for use with Campbell Hausfeld air compressors. This is the push-in fitting for the check valve which is sold separately. It is a quick-connect style fitting that is designed to accommodate for 1/4

The gasket-oil seal and o-ring kit is sold as a set that contains all the necessary parts. These genuine items are supplied by the original equipment manufacturer for use with Campbell Hausfeld compressors. During the installation process, a socket set and a wrench set might be needed to replace these parts. They are made of plastic and rubber and will need to be replaced if they break.