This part is the replacement ice tray for your refrigerator. The tray is made of white plastic and is approximately 9 inches in length, and 3 inches in width. It has the capacity for 8 ice cubes. The ice tray can be filled up with water and is the mold that shapes the ice cubes. If your current ice tray is cracked, warped, or if mineral d...Read moreeposits have settled inside it, it may cause the ice cubes to stick. This part is sold individually and is an authentic OEM part.
This condenser cooling fan motor is an essential component for maintaining your refrigerator’s performance. It circulates air over the condenser coils located at the back of the unit, helping to dissipate heat and regulate internal temperatures. Proper airflow prevents overheating and ensures efficient cooling. If your refrigerator is run...Read morening too warm or too cold, making unusual noises, or failing to start, the fan motor may need replacement. Installation typically involves disconnecting power, removing the rear access panel, and securing the new motor in place. Designed for durability, this part plays a critical role in keeping your appliance operating smoothly.
This part holds the ice once it's released from the icemaker. When activated, the auger rotates and pushes ice out of the bin through the chute to the user.
This assembly includes the auger and blades.
This evaporator fan motor is a replacement drive component designed to circulate air across cooling surfaces. It supports even temperature distribution and is commonly replaced when airflow decreases or the motor fails to run smoothly.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
The ice tray had warped and dumped water, which then froze down through the ice bucket and below.
8 of 8 peoplefound this instruction helpful.
George from ATLANTA, GA
Easy
Less than 15 mins
Screw drivers
To replace the warped tray, I found the service manual (pg. 124 below) which took some interpreting. Removed the lever. Then removed the assembly by two screws that are forward to the unit and go upwards. The insulation, sensor, and sensor cover are simply pulled down and off and the unit separated to removed the tray, and
... Read morethen insert the new tray. Proceed in reverse. Takes only a few minutes.
/Users/grf/Desktop/fridge ice tray.pdf
Read less
Was this helpful?
Thank you for voting!
Replace Gasket on refrigerator door
6 of 10 peoplefound this instruction helpful.
Curtis from DEMOPOLIS, AL
A Bit Difficult
30 - 60 mins
Screw drivers
The replacement gasket does not have as strong a magnet as the original one. I removed the old one carefully so as not to cause more damage in case I have to put it back. Using Tongue suppressor I pushed new gasket into place and put a thin coating of protelem jelly on the gasket. I just have to make sure the door is closed each time to
... Read morebe sure of good seal.
Read less
Was this helpful?
Thank you for voting!
whater valve whith a defected selenoid and water leaks.
2 of 2 peoplefound this instruction helpful.
Albert from NORTHRIDGE, CA
Really Easy
30 - 60 mins
Screw drivers, Socket set, Wrench set
First ,I unplug the refrigerator . 2nd i remove the back cover, clean the dust. 3th disconnect the water line, remove the all valve.. 4th unplug all the wires and code ea with a No,remove the water lines 5th replace the valve reconnect the wires and water lines.replace the back cover at last screw back the w
... Read moreater line.check for water leaks . i found ease the valve replacement installation. .Thanks for the video.