GL6000ER (AWYABBL) LG Air Conditioner - Overview

Diagrams for GL6000ER

See every part. Know exactly what you need.

Section

Parts for the GL6000ER

$46.34

Remote Control Assembly

★★★★★

(6)

Part #AKB73795706

This remote control is a device for adjusting your air conditioner settings. It requires two AAA batteries for operation. A malfunctioning remote control may have unresponsive buttons or signs of physical damage. You may also notice that your air conditioner does not consistently or promptly respond to commands from the remote control. Yo...Read more

Read less

Thermistor,NTC

★★★★★

(1)

Part #6323A20012C

This part is a thermistor assembly and it works in conjunction with your room air conditioner. The thermistor is a sensor that attaches to the control board of your air conditioner. Once attached it will help regulate and monitor the temperature within the room. This model measures to be slightly under 20 inches in length, and it is black...Read more

Read less

$8.55

CLAMP,SPRING

Part #MBU64446302

GRILLE ASSEMBLY,FRONT(IN

Part #3531A20168M

Curtain Installation Kit

Part #3127A20083A

This is used for window air conditioners.

$94.13

POWER CORD ASSEMBLY

Part #EAD63469501

DAMPER,COMPRESSOR

Part #5040AR4195E

Fan Assembly,Cross Flow

Part #5901A20020A

Panel Assembly,Control

Part #3721A20133L

Window,Display

Part #3790A20065A

Grille,Inlet

Part #3530A10158C

Escutcheon

Part #3831A20055C

Common Symptoms of the GL6000ER

How this model fails, and the parts that fix it.

Does not shut off

Fixed by
these parts

Show All

Repair Tips From Fixers Like You

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Bad thermistor

1 person found this instruction helpful.

Cindy from Baltimore, MD
Really Easy
15 - 30 mins
Screw drivers

Took front cover off air conditioner and pulled it a little forward out of the outdoor housing. I then flipped the LED display section out to the left and exposed the patch panel. The next step was to remove the panel with a small screwdriver and disconnect the old thermistor plug. I then plugged in the new one, remove the old one from th ... Read more

Read less

Was this helpful?

Bad thermister, unit would run constantly without cycling.

0 of 2 people found this instruction helpful.

Gary from Aurora, CO
Really Easy
Less than 15 mins
Screw drivers

Remove the front cover. Slide the unit forward a few inches from the case. Remove 1 screw from the top on the control box. Unsnap the old thermister leads going into the circuit board. Snap in the new thermister and place the end in the plastic holder in front of the coils. Install front cover.

Was this helpful?