Models
>
GGS36W
GGS36W Thermador Cooktop - Overview
Sections of the GGS36W
[Viewing 17 of 17]Keep searches simple, eg. "belt" or "pump".
TUBE
PartSelect #: PS8698345
Manufacturer #: 00189023
This authentic OEM venturi tube, also known as a gas tube connector or surface burner tube, mixes gas and air to create the proper fuel-air mixture for combustion in your range. It is typically locate...
$62.26
In Stock
NUT
PartSelect #: PS8698313
Manufacturer #: 00188978
This nut is designed for use with different makes and models of ranges and cooktops and is a genuine OEM part. This nut is 1mm thick and is 22-threads-per-inch, and is made of high-quality, durable st...
$23.51
On Order
SWITCH
PartSelect #: PS8714254
Manufacturer #: 00428049
This OEM control panel switch, also known as a limit switch or limit sensor, is mounted within the control panel housing on ranges. It is a small component that is responsible for transferring power t...
$20.14
In Stock
Cooktop Installation Bracket
PartSelect #: PS8698292
Manufacturer #: 00188954
This installation bracket is for cooktops. Installation bracket holds the cooktop in place to the surrounding countertop.
$34.63
In Stock
Questions And Answers for GGS36W
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Part discontinued by Bosch. Found replacement part at Parts Select
Removed knobs and venturies. Unplugged electrical inputs. Lifted top plate. Replaced potentiometer. Replaced parts and plugged in electric supplies. Tested. Piece of cake, except for locating replacement potentiometer.
Parts Used:
-
Charlie from INDIAN SPGS, AL
-
Difficulty Level:Very Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Wrench (Adjustable)
1 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
the lens did not fit It did not fit in the hole of the range top
I has to file the bottom edge on a slight angle so the lens would fit in the hole. Also I had to file the top edge cause it had little tabs and and also had to file the edge below the top of the lens then it would snap in so I have to say the woman I talked to said she guaranteed me it would fit and it didn't
Parts Used:
-
richard from HOPATCONG, NJ
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
1 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!