GFS165 (MN10) Caloric Refrigerator - Overview

Diagrams for GFS165

See every part. Know exactly what you need.

Parts for the GFS165

High Limit Thermostat – Part Number: 489P3

Part #489P3

If you notice that your dryer will not start, shuts off too soon or provides too much heat, you may need to replace your high limit thermostat. This high limit thermostat acts as a safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this piece will shut down power to the heating elem...Read more

Read less

$47.40

Igniter

★★★★★

(9)

Part #WP37001308

The bracket is no longer included.

$105.35

Refrigerator Cold Control Thermostat

★★★★★

(2)

Part #1123394

This cold control thermostat has a temperature range from 29.5 degrees Fahrenheit to 16.5 degrees Fahrenheit and a capillary length of 35 inches.

THERMOSTAT,LOW LIMIT

Part #56591

SWTCH-PRCT

Part #314210

CENTER RAIL-ALMOND

Part #56886L

DISCONTINUED

Part #Y56724

DISCONTINUED

Part #Y56236

COVER, HINGE - WHITE

Part #56624W

DISCONTINUED

Part #56717

DISCONTINUED

Part #56719

DISCONTINUED

Part #56501

Common Symptoms of the GFS165

How this model fails, and the parts that fix it.

Repair Tips From Fixers Like You

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Gas dryer was not getting hot.

11 of 16 people found this instruction helpful.

William from Placentia, CA
Easy
30 - 60 mins
Nutdriver, Screw drivers

Removed top of dryer and front panel. Keeping the front door closed I was able to start the unit and observe if the gas was igniting to heat the unit.
Found that no flame was present.
Examined the ignitor (found the locatino after utilizine this website parts diagram) and noticed it was cracked.
Ordered the new part and it ... Read more

Read less

Was this helpful?

Would not lite

4 of 4 people found this instruction helpful.

RICHARD from LINDSTROM, MN
Really Easy
15 - 30 mins
Screw drivers, Socket set

Remove igniter and replaced easy to do

Was this helpful?

At the end of the drying cycle, the clothes had a bunt smell. I checked the lower compartment of the dryer and found the limit thermostat in two pieces and realized this could be the culprit. I was able to snap them together, but this did not work, therefore a new stat

4 of 5 people found this instruction helpful.

James from Mokena, IL
Easy
15 - 30 mins
Pliers, Screw drivers, Socket set

First I unpluged the dryer, removed the two screws from the bottom access panel. I used a small socket to remove the screws securing the limit stat to the burner chamber, nut driver was too long.
I installed the new limit stat with the two screws and attached the two leads. Plugged in the dryer and conducted a test run, burner ig ... Read more

Read less

Was this helpful?