See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Gas dryer was not getting hot.
11 of 16 peoplefound this instruction helpful.
William from Placentia, CA
Easy
30 - 60 mins
Nutdriver, Screw drivers
Removed top of dryer and front panel. Keeping the front door closed I was able to start the unit and observe if the gas was igniting to heat the unit. Found that no flame was present. Examined the ignitor (found the locatino after utilizine this website parts diagram) and noticed it was cracked. Ordered the new part and it
... Read morearrived two days later. Simple installation and ta daaa....ignitor works, hot dryer again. *Only reason it took over half an hour was because I cleaned out all the internal vents while the unit was opened. Basic mechanical abilities required here but remember to unplug the unit while working on it!
Read less
Was this helpful?
Thank you for voting!
Would not lite
4 of 4 peoplefound this instruction helpful.
RICHARD from LINDSTROM, MN
Really Easy
15 - 30 mins
Screw drivers, Socket set
Remove igniter and replaced easy to do
Was this helpful?
Thank you for voting!
Gas smell
2 of 2 peoplefound this instruction helpful.
Garrett from PHILADELPHIA, PA
Really Easy
Less than 15 mins
Nutdriver
After removing the front panel, the igniter just just snaps into the bracket.