Models
>
GFC100--23
GFC100--23 General Electric Food Waste Disposer - Overview
Sections of the GFC100--23
[Viewing 1 of 1]Keep searches simple, eg. "belt" or "pump".
Disposer Splash Guard
PartSelect #: PS257945
Manufacturer #: WC3X124
This splash guard attaches to the garbage disposal in your sink, and prevents water and food debris from splashing back up when the disposal is operating. If your current splash guard is damaged, you ...
$12.72
In Stock
Questions And Answers for GFC100--23
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Splash guard worn out
pulled out the old and stuck in the new--so easy a caveman could do it.
Parts Used:
-
Aubrey from Hugo, OK
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
5 of 6 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
old one wore out and had shrunk and coming loose.
Turn off power to unit (switch off) Put rubber gloves on and pulled out old guard. Then cleaned the area on the sides and the under the lip with wet paper towels. Crud had built up. Once clean push the new guard in. Since it was new it was tight .push down moving finger pressure around until it seated. Works fine.
Parts Used:
-
Tom from ORLANDO, FL
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
old splash gard became loose, felt always into grinder
just wet the surface of the new part and pushed it with some force into its place. It was real easy
Parts Used:
-
robert from coral gables, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!