GC2227EEDW Admiral Refrigerator - Instructions

Removed 4 screws and disconnect the circuit board, replaced the broken door and reassembled the unit. Solenoid did not need to be replaced, only the ice door. About 15 minutes and about 90$ saved in labor.

First remove srews from front icewater panel
Second pushed panel up to remove and disconect electric conection.
Third rmoved broke ice door and installed new one in holder frame.
Fourth reversed steps two and one.
Job cpompleted.

I took the bottom tray out removed 2 screws that were under it. Pop the decorative trim piece off and remove three screws under it. Pull the dispenser out and pop the new door into tabs. I didn't replace the solenoid. Save that for later if I need to.

Popped out the old switch and replaced it with the one dying

I removed the two screws from the front door panel, unhooked the wire, removed three more screws and removed the broken door. I replaced the door and replaced everything in reversed order. I did not need to replace the solenoid so I still have that if needed in the future, The instructions were so easy, it took less than 5 minutes and I estimate saving about $90.00 on a sevice call after deducting the cost of the part from PartSelect.
I will check out PartSelect for future repair jobs.

Thanks

Pried out old part with screwdriver. Unplugged. When new part came, just plugged it in and pushed the part into place.

Very easy to install. Just snap in and done.

took door off put part in, put door back on. that is it.
The best thing about this fix is the lady that took my order. She knew what my problem was and she knew which part was needed. I give all the credit to her. she did me a fine job. Thank you very much.

Removed all screws on back and 4 on front. That part is easy IF you have a Torx of the right size. Slip out the ice bin a bit and replace the drive ring. Reassembly is a bit harder since some internal shift can occur -- rotate or tilt the whole assembly to get two -- I think -- screws started. No need to over tighten screws; snug is good enough.

Simply to do.

Followed included instructions. Thank you.

The switch fix but did not fix the problem. I assumed the wires go on the same way as on the old switch. Is it possible if one light Burns out, the other will not work either?

Removed approx. 5 phillips screws to access the flap from the outside of the freezer door and R & R'd the flap, then repaced the screws. Fairly simple installation. Most impressive was how easy it was to find the part here and the quick delivery.

Removed old ejector arm and installed new part.

Removed screws, removed parts, spring popped off, didn't know where it was actually at, had a difficult time getting the spring in the right place, (the directions were not that clear), put back together 6 times before I got it right.