GA7021 Makita Angle Grinder - Overview

This is an authentic replacement field assembly which is supplied by the original equipment manufacturer for use with Makita angle grinders. In conjunction with an armature, it drives the unit. A field is usually damaged by overloading the power tool, or because of a bad armature, it is highly recommended to replace both carbon brushes when replacing a field. Please note this high-quality item is sold individually.

This cord is a genuine Makita replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Over time, power tool cords will wear out or become frayed. We recommend replacing a cord as soon as signs of wear are visible. Power Cord Specifications: • 2 Prongs • 2 Wires • 14 Gauge • 8 Feet Long

This authentic replacement ball bearing which is supplied by the original manufacturer, it is specially designed for use with Makita power tools. Ball bearings are used to reduce friction between rotating parts, they experience constant wear from pressure, heat, vibration, and friction eventually requiring replacement to maintain peak per...Read moreformance. It is generally used as one of the armature bearings, for correct application make sure to check appropriate diagrams of your model. This part is made of high-quality metal and it is sold individually.

Set of 2 Carbon Brushes with wire leads and brush springs attached. The set contains genuine Makita replacement parts, and comes packaged in a Makita retail box. This brush set will fit the Makita tools listed at the bottom of the page. • Worn brushes frequently are the cause behind a motor running poorly. • Replacing brushes ...Read morecan fix a motor that's operating intermittently. • New brushes can restore a motor's electric braking. Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

This manufacturer sourced replacement pin is made out rubber and it is sold individually. It acts as a cushion/spacer in a variety of Makita power tools. This is a standard piece of hardware and it has multiple applications based on your tool. Please refer to diagrams for correct application.