G3510R Makita Generator - Overview

Included in part number 284-46200-00

This is a genuine replacement part sourced from the original manufacturer for use with lawnmower engines. The solenoid is commonly used to complete the electrical relay between the battery and the starter motor. This starter motor is available as an individual replacement part, please see model diagram for associative parts.

This gasket, also known as the oil drain plug gasket, is a ring-shaped, metal component used in outdoor power engines. It is supplied by the manufacturer and can be found at the bottom of the engine oil pan where the drain plug is installed. The gasket is responsible for sealing the area between the oil drain plug and the engine block to ...Read moreprevent oil from leaking during oil changes. Over time the gasket can wear down, corrode, or crack. If the gasket can no longer seal the area, oil will escape from the oil pan, leading to inadequate lubrication, increased friction, and engine damage. Before you begin the repair, drain the oil from the engine to prevent contamination. Use a wrench to loosen and remove the oil drain plug. Peel off the old gasket, and thoroughly clean the drain plug and oil pan surface. Install the new gasket and ensure that it sits firmly on the oil pan. Finally, reinstall the drain plug, and be careful to avoid overtightening it.

This is a genuine manufacturer-supplied part which is made for Makita generators. It is a special packing which helps to provide a tight fit between connected components. Refer to the parts diagram for your model to ensure the exact location and the correct application of this hardware. You may require a wrench when replacing this part. Note, this packing is made of high-quality material and is sold individually.

Included in part number 277-62309-00