G2800L Makita Generator - Overview

A bowl gasket is designed to create a tight and secure seal between the carburetor bowl and main body of the carburetor, and when it is damaged or not working properly it can cause fuel contamination, loss of engine vacuum and air leakage. This gasket is compatible with various models of engines and is sold as an individual part, without ...Read moreany other hardware. Due to exposure to heat and fuel this gasket can rip, crack and even shrink, leading to fuel leaks as well as other problems for your engine. It is easier to replace this gasket than to maintain it, and you can replace it with a few tools, such as wrenches and screwdrivers. Depending on your model, that process may look different, but ensure the engine is turned off before you disconnect and remove the hardware securing the bowl. Then you carefully lift the bowl off the carburetor, and clean the mating surfaces, after which you replace the gasket and reassemble the carburetor body, ensuring it is all aligned properly and tighten to its manufacturing standard.

This rod spring is an original part that is designed for use with Subaru / Robin engines commonly installed on a variety of lawn and garden equipment. The spring applies tension on the governor rod allowing it to retract. Over time it may wear out and lose tension eventually requiring a replacement. It is made of high-quality metal and is...Read more sold as an individual component. Check the diagrams for your model for the exact location and the correct installation of this rod spring. It is a simple repair that should only require pliers to remove the old part and attach the new one.

This gasket, also known as the oil drain plug gasket, is a ring-shaped, metal component used in outdoor power engines. It is supplied by the manufacturer and can be found at the bottom of the engine oil pan where the drain plug is installed. The gasket is responsible for sealing the area between the oil drain plug and the engine block to ...Read moreprevent oil from leaking during oil changes. Over time the gasket can wear down, corrode, or crack. If the gasket can no longer seal the area, oil will escape from the oil pan, leading to inadequate lubrication, increased friction, and engine damage. Before you begin the repair, drain the oil from the engine to prevent contamination. Use a wrench to loosen and remove the oil drain plug. Peel off the old gasket, and thoroughly clean the drain plug and oil pan surface. Install the new gasket and ensure that it sits firmly on the oil pan. Finally, reinstall the drain plug, and be careful to avoid overtightening it.

It is a genuine OEM component which is specially produced for use with a Subaru / Robin engines that are commonly installed on a variety of lawn and garden equipment. This replacement part provides a tight seal for the float chamber body. Unfortunately, over time the material may wear out or get damaged eventually requiring a replacement....Read more Please make sure to check appropriate diagrams of your model for the correct application. It is made of a durable material and is sold individually. You will need a wrench to remove and resecure the bolt that secures it to the float chamber body.

Included in part number 277-62309-00

Included in part number 277-11001-31