G100K2 (Type MMB) Honda Engine - Overview

This is a genuine manufacturer-sourced replacement component which is specially designed for use with Honda engines commonly installed on lawn and garden equipment. Its purpose is to provide an air-tight seal for the carburetor. Over time gaskets tend to wear out and crack eventually requiring replacement to maintain peak performance. This part is made of high-quality composite material and it is sold individually.

This is an authentic Honda replacement part, sourced from the original manufacturer for use with small engines. The special air cleaner element is commonly used to prevent dust and debris from entering the engine's air intake. This air cleaner element can wear out over time and replacing a worn air cleaner is part of normal engine maintenance. This air filter is available as an individual replacement part.

This is a genuine Honda replacement part. The pilot screw is designed by the manufacturer for use in small engines. This part includes a metal screw and a spring, and is used to adjust the flow of fuel and air in the carburetor. You will require a screwdriver when replacing these parts.

This is an original Honda replacement part manufactured for use with small engines. This is the seal for the oil cap/gauge. This intended to be a replacement for a worn out seal and is sold individually, please note the cap is available separately.

This Fuel strainer is an OEM part that is sourced directly from Honda. This part is sold individually and is used to filter the gas of dirt and debris before it enters the engine which can cause the engine to clog. Over time this filter will become clogged itself, therefore, losing its effectiveness in straining the fuel. This part is made of plastic with a foam filter inside.

A ball bearing is a type of rolling part that consists of an inner and outer-ring, and a set of steel balls fit between them that allow rotational movement with reduced amounts of friction. This ball bearing is designed for use within the crankcase of various models of small engine equipment such as generator, tiller and lawn mower/tracto...Read morer, and is used to support the crankshaft so it can rotate smoothly and withstand the various mechanical pressures sounding it. This bearing is sold as an individual OEM part and features a 0.68-inch (17mm) inner-diameter, 1.38-inch (35mm) outer-diameter and .47-inch (12mm) width. If you notice any sort of excessive vibrations, noise, wobbling, or significantly reduced engine performance, the ball bearing is likely worn out or damaged, and in need of replacing, but it is best to inspect the crankcase area for any other possible issues. To replace this bearing, you will need a screwdriver and socket wrench to gain access to the inner portion of your engine, where the crankcase is located. Disconnect the spark plug and follow the user manual and the official disassembly procedure according to the manufacturer, which normally involves removing the engine cover, carburetor and ignition coil. With access to the bearing, carefully remove it before cleaning and properly lubricating the area. Install the new bearing and make sure it and the crankshaft are properly aligned before you reassemble the rest of the motor.