G0059396 (GP5500) Generac Generator - Overview

This item has been sourced from the original manufacturer to be used with portable generators from Generac. The valve attaches to the fuel tank and is used to either allow fuel to the engine or to prevent the flow of fuel. This item is available as an individual replacement part.

This fuel filter is a high quality item that is sourced from original equipment manufacturer for use with Generac portable generators. This part acts as a fuel strainer to remove any debris from the fuel that is poured into the tank. Please note this part is made from durable plastic with mesh filter material and it is sold individually.

This is a genuine OEM approved replacement in-tank fuel filter, it is designed for use with Generac portable generators. The purpose this part is to ensure the fuel that is supplied into the carburetor is free of dirt and any other contaminants. Over time it may get dirty and logged restricting the fuel flow, if the engine is not getting ...Read moreenough fuel, it is time to replace the fuel filter. It is a durable plastic body in-tank fuel filter which is sold individually.

This is a genuine OEM sourced replacement part which is specially designed for use with Generac portable generators. The purpose of this fuel line is to supply the fuel from the tank to the carburetor. By pressing on the primer bulb it will fill the carburetor with fuel, once it is full the excess fuel will be forced back into the tank th...Read morerough the return line. It is made of durable flexible rubber and it is sold individually.

This pipe-return is a genuine OEM sourced component. It is specially designed for use with Generac portable generators. This is the hose that the fuel travels through. When you press the primer bulb, it will purge all the air out of the carburetor and fill its chambers with fuel. The excess fuel is then forced back into the tank through t...Read morehe return hose. Over time these rubber hose will become brittle and they may begin to crack eventually requiring replacements. Please note, one durable flexible fuel hose is included. Check the appropriate diagrams for your model to ensure the proper repair procedure.

This part is available as an individual replacement part. The automatic voltage regulator goes between the stator and the cover alternator inlet. A screwdriver might be helpful during the installation of this part. It will need to be replaced if it breaks. This is an authentic OEM part for use in Generac generators.

This is an authentic replacement part manufactured for use with Generac generators. The special cotter pin is commonly used to fasten the wheel to the axle of the generator's frame. This cotter pin is available as an individual replacement part, please see model diagram for associative parts.

This is an authentic replacement part manufactured for use with Generac generators. The snap button is commonly used to secure the handle to the handle bracket. This snap button is available as an individual replacement part, please see part list for associative parts.